Geology topics

I. Ryder

Publications and source records attributed to I. Ryder.

3 recordsLinked to original sources

USGS2012

Aftershock seismicity of the 2010 Maule Mw=8.8 Chile, earthquake: Correlation between co-seismic slip models and aftershock distribution?

The 27 February 2010 Maule, Chile (Mw=8.8) earthquake is one of the best instrumentally observed subduction zone megathrust events. Here we present locations, magnitudes and cumulative equivalent moment of the first -2 months of aftershocks, recorded on a temporary network deployed within 2 weeks of the occurrence of the mainshock. Using automatically-determined onset times and a back projection approach for event association, we are able to detect over 30,000 events in the time period analyzed. To further increase the location accuracy, we systematically searched for potential S-wave arrivals and events were located in a regional 2D velocity model. Additionally, we calculated regional moment tensors to gain insight into the deformation history of the aftershock sequence. We find that the aftershock seismicity is concentrated between 40 and 140 km distance from the trench over a depth range of 10 to 35 km. Focal mechanisms indicate a predominance of thrust faulting, with occasional normal faulting events. Increased activity is seen in the outer-rise region of the Nazca plate, predominantly in the northern part of the rupture area. Further down-dip, a second band of clustered seismicity, showing mainly thrust motion, is located at depths of 40–45 km. By comparing recent published mainshock source inversions with our aftershock distribution, we discriminate slip models based on the assumption that aftershocks occur in areas of rapid transition between high and low slip, surrounding high-slip regions of the mainshock.

Geophysical Research Letters↗

USGS2011

Lower crustal relaxation beneath the Tibetan Plateau and Qaidam Basin following the 2001 Kokoxili earthquake

In 2001 November a magnitude 7.8 earthquake ruptured a 400 km long portion of the Kunlun fault, northeastern Tibet. In this study, we analyse over five years of post-seismic geodetic data and interpret the observed surface deformation in terms of stress relaxation in the thick Tibetan lower crust. We model GPS time-series (first year) and InSAR line of sight measurements (years two to five) and infer that the most likely mechanism of post-seismic stress relaxation is time-dependent distributed creep of viscoelastic material in the lower crust. Since a single relaxation time is not sufficient to model the observed deformation, viscous flow is modelled by a lower crustal Burgers rheology, which has two material relaxation times. The optimum model has a transient viscosity 9 × 10 17 Pa s, steady-state viscosity 1 × 10 19 Pa s and a ratio of long term to Maxwell shear modulus of 2:3. This model gives a good fit to GPS stations south of the Kunlun Fault, while displacements at stations north of the fault are over-predicted. We attribute this asymmetry in the GPS residual to lateral heterogeneity in rheological structure across the southern margin of the Qaidam Basin, with thinner crust/higher viscosities beneath the basin than beneath the Tibetan Plateau. Deep afterslip localized in a shear zone beneath the fault rupture gives a reasonable match to the observed InSAR data, but the slip model does not fit the earlier GPS data well. We conclude that while some localized afterslip likely occurred during the early post-seismic phase, the bulk of the observed deformation signal is due to viscous flow in the lower crust. To investigate regional variability in rheological structure, we also analyse post-seismic displacements following the 1997 Manyi earthquake that occurred 250 km west of the Kokoxili rupture. We find that viscoelastic properties are the same as for the Kokoxili area except for the transient viscosity, which is 5 × 10 17 Pa s. The viscosities estimated for the Manyi and Kokoxili areas are consistent with constraints obtained from other earthquakes in the northwest and south central parts of the Tibetan Plateau.

Tibetan Plateau and Qaidam Basin↗

USGS2009

The postseismic response to the 2002 M 7.9 Denali Fault earthquake: Constraints from InSAR 2003-2005

InSAR is particularly sensitive to vertical displacements, which can be important in distinguishing between mechanisms responsible for the postseismic response to large earthquakes (afterslip, viscoelastic relaxation). We produce maps of the surface displacements resulting from the postseismic response to the 2002 Denali Fault earthquake, using data from the Canadian Radarsat-1 satellite from the periods summer 2003, summer 2004 and summer 2005. A peak-to-trough signal of amplitude 4 cm in the satellite line of sight was observed between summer 2003 and summer 2004. By the period between summer 2004 and summer 2005, the displacement rate had dropped below the threshold required for observation with InSAR over a single year. The InSAR observations show that the principal postseismic relaxation process acted at a depth of ∼50 km, equivalent to the top of the mantle. However, the observations are still incapable of distinguishing between distributed (viscoelastic relaxation) and localized (afterslip) deformation. The imposed coseismic stresses are highest in the lower crust and, assuming a Maxwell rheology, a viscosity ratio of at least 5 between lower crust and upper mantle is required to explain the contrast in behaviour. The lowest misfits are produced by mixed models of viscoelastic relaxation in the mantle and shallow afterslip in the upper crust. Profiles perpendicular to the fault show significant asymmetry, which is consistent with differences in rheological structure across the fault.

Geophysical Journal International↗