Geology Reports⌕ Search

Geology topics

I. Demir

Publications and source records attributed to I. Demir.

6 recordsLinked to original sources
USGS2001

Formation and use of coal combustion residues from three types of power plants burning Illinois coals

Coal, ash, and limestone samples from a fluidized bed combustion (FBC) plant, a pulverized coal combustion (PC) plant, and a cyclone (CYC) plant in Illinois were analyzed to determine the combustion behavior of mineral matter, and to propose beneficial uses for the power plant ashes. Pyrite and marcasite in coal were converted during combustion to glass, hematite and magnetite. Calcite was converted to lime and anhydrite. The clay minerals were altered to mullite and glass. Quartz was partially altered to glass. Trace elements in coal were partially mobilized during combustion and, as a result, emitted into the atmosphere or adsorbed on fly ash or on hardware on the cool side of the power plants. Overall, the mobilities of 15 trace elements investigated were lower at the FBC plant than at the other plants. Only F and Mn at the FBC plant, F, Hg, and Se at the PC plant and Be, F, Hg, and Se at the CYC plant had over 50% of their concentrations mobilized. Se and Ge could be commercially recovered from some of the combustion ashes. The FBC ashes could be used as acid neutralizing agents in agriculture and waste treatment, and to produce sulfate fertilizers, gypsum wall boards, concrete, and cement. The PC and CYC fly ashes can potentially be used in the production of cement, concrete, ceramics, and zeolites. The PC and CYC bottom ashes could be used in stabilized road bases, as frits in roof shingles, and perhaps in manufacturing amber glass. ?? 2001 Elsevier Science Ltd. All rights reserved.

Fuel↗
USGS1998

Environmentally critical elements in channel and cleaned samples of Illinois coals

Sixteen trace and minor elements that occur in coal are listed among 189 substances identified as ‘hazardous air pollutants’ (HAPs) in the US Clean Air Act Amendments of 1990. We investigated the occurrence and cleanability of the 16 HAPs in Illinois coals, as a contribution to the discussion about the potential effect of pending environmental regulations on the future use of these coals in power generation. The average ash content of the samples of conventionally cleaned as-shipped coals is about 20% lower than that of standard channel samples. Conventional cleaning reduces the average concentrations of As, Cd, Co, Hg, Mn, Ni, Pb, Sb and Th in the as-shipped coals by more than 20% relative to channel samples. Thus, basing assessments of health risks from emissions of HAPs during coal combustion on channel samples without appropriate adjustment would overestimate the risk. Additional cleaning by froth-flotation reduces the ash content of finely-ground as-shipped coals by as much as 76% at an 80% combustibles recovery. Although the average froth-flotation cleanability for the majority of HAPs is less than that for ash, the cleanabilities in some individual cases approaches, or even exceeds, the cleanability for ash, depending on the modes of occurrences of the elements.

Illinois↗
USGS1993

SEM-EDX and isotope characterization of the organic sulfur in macerals and chars in Illinois Basin coals

Two samples of the Herrin (Illinois No. 6) Coal and one sample of the Colchester (Illinois No. 2) Coal from the Illinois Basin were studied to evaluate the spatial distribution of organic sulfur within macerals occurring next to pyrite grains, both in the raw coal and their chars. The chars were produced by pyrolysing the coal at 250–550°C in a nitrogen atmosphere. Representative splits of the coals and their chars were mounted in epoxy and polished for optical microscopy and scanning electron microscopy-energy dispersive x-ray spectroscopy (SEM-EDX). Determinations of organic sulfur concentrations were made at 996 locations within macerals, mostly vitrinite, around 115 grains of pyrite and at 50 locations around 5 pores in chars. The pyrite considered here is restricted to the disseminated type within macerals. On the average, the organic sulfur content increased near pyrite grains after the coals were charred at 550°C, indicating that some of the pyritic sulfur released during charring was retained within the organic matrix rather than being emitted to the atmosphere. One of the coal samples and its chars were isotopically characterized by chemically separating the pyritic and organic sulfur fractions, followed by analyzing the isotopes of the sulfur forms with a Nuclide 6–60 ratio mass spectrometer. The sulfur isotope (δ 34 S) data confirmed the movement of pyritic sulfur into the macerals after charring to 550°C. About 18% of the organic sulfur that remained in the 550°C char had originally been pyritic sulfur in the untreated coal.

Organic Geochemistry↗
USGS1991

Variation of organic sulfur in macerals of selected Illinois Basin coals

An electron microbeam technique was used to determine the distribution of organic sulfur in the main macerals of five Illinois Basin coals. On average, sporinites are the highest, inertinites the lowest, and vitrinites intermediate in organic sulfur for each coal. The observed differences are likely due to varying affinities of the different pre-maceral materials for sulfur and/or local variation in the production of H 2 S primarily during the peat stage. Investigation of molecular structures of individual macerals in relation to the findings of this study may delineate the relative abundance of organic sulfur in various organic compounds and thus lead to the development of efficient desulfurization processes.

Organic Geochemistry↗