Geology topics

Greg Hirth

Publications and source records attributed to Greg Hirth.

4 recordsLinked to original sources

USGS2026

Measuring stress In high pressure deformation experiments with high speed fiber-optics

High‐pressure, high‐temperature rock deformation experiments are essential for understanding deep Earth processes, but accurately measuring stress is challenging due to the inaccuracy introduced by seal friction within the apparatus and large inertia, which affects earthquake process measurements made far from the experimental fault. To overcome these limitations, we developed and implemented a simple, compact fiber‐optic sensor based on an External Cavity Fabry–Perot Interferometer for in situ load measurement on a piston inside the pressure vessel of a Griggs‐type high‐pressure apparatus. The sensor can be used at sample temperatures up to 800°C for both slow creep and fast rupture testing with bandwidth capability from DC to 6 MHz. Two important experimental results are described: (1) the first direct measurements of seal friction in this apparatus type; these measurements record seal friction approximately one‐tenth of the confining pressure under both low (150 MPa) and high (1 GPa) pressure conditions; and (2) high‐temporal resolution capture of dynamic stress drops during stick‐slip faulting events at high‐confining pressure, revealing near‐fault wave propagation details, high‐frequency oscillations, and implying high‐transient slip rates (6–12 m/s) previously inaccessible with external sensors.

The Seismic Record↗

USGS2016

“Ductile to brittle” transition in thermally stable antigorite gouge at mantle pressures

General shear experiments on antigorite-rich serpentinite show a transition from ductile (distributed) to brittle (localized) deformation with increasing temperature from 300°C to 500°C at confining pressures from 1 to 2 GPa. The coefficient of friction associated with slip along fractures decreases from 0.23 to 0.07 with an increase in temperature from 300°C to 500°C. Velocity stepping experiments exhibit a positive rate dependence, as parameterized by a-b values, that decrease modestly with increasing temperature from ~0.015 at 300°C to ~0.01 at 500°C. Fractures contain fine-grained foliated antigorite, and there is no evidence of dehydration. All samples have a moderate foliation and show microstructural evidence for both plastic and brittle deformation mechanisms. Under certain conditions the transition to brittle deformation, at high pressures and temperatures in antigorite, might generate earthquakes, which could explain the occurrence of some intermediate-depth seismicity within subduction zones in serpentinized regions that are too cold to induce dehydration.

Journal of Geophysical Research B: Solid Earth↗

USGS2016

Effective stress, friction and deep crustal faulting

Studies of crustal faulting and rock friction invariably assume the effective normal stress that determines fault shear resistance during frictional sliding is the applied normal stress minus the pore pressure. Here we propose an expression for the effective stress coefficient α f at temperatures and stresses near the brittle-ductile transition (BDT) that depends on the percentage of solid-solid contact area across the fault. α f varies with depth and is only near 1 when the yield strength of asperity contacts greatly exceeds the applied normal stress. For a vertical strike-slip quartz fault zone at hydrostatic pore pressure and assuming 1 mm and 1 km shear zone widths for friction and ductile shear, respectively, the BDT is at ~13 km. α f near 1 is restricted to depths where the shear zone is narrow. Below the BDT α f = 0 is due to a dramatically decreased strain rate. Under these circumstances friction cannot be reactivated below the BDT by increasing the pore pressure alone and requires localization. If pore pressure increases and the fault localizes back to 1 mm, then brittle behavior can occur to a depth of around 35 km. The interdependencies among effective stress, contact-scale strain rate, and pore pressure allow estimates of the conditions necessary for deep low-frequency seismicity seen on the San Andreas near Parkfield and in some subduction zones. Among the implications are that shear in the region separating shallow earthquakes and deep low-frequency seismicity is distributed and that the deeper zone involves both elevated pore fluid pressure and localization.

Journal of Geophysical Research B: Solid Earth↗

USGS2015

The role of fluid pressure on frictional behavior at the base of the seismogenic zone

To characterize stress and deformation style at the base of the seismogenic zone, we investigate how the mechanical properties of fluid-rock systems respond to variations in temperature and strain rate. The role of fluids on the processes responsible for the brittle-ductile transition in quartz-rich rocks has not been explored at experimental conditions where the kinetic competition between microcracking and viscous flow is similar to that expected in the Earth. Our initial analysis of this competition suggests that the effective stress law for sliding friction should not work as efficiently near the brittle-ductile transition as it does at shallow conditions

Geology↗