Geology Reports⌕ Search

Geology topics

Gerald K. Moore

Publications and source records attributed to Gerald K. Moore.

10 recordsLinked to original sources

What is a picture worth? A history of remote sensing

Remote sensing is the use of electromagnetic energy to measure the physical properties of distant objects. It includes photography and geophysical surveying as well as newer techniques that use other parts of the electromagnetic spectrum. The history of remote sensing begins with photography. The origin of other types of remote sensing can be traced to World War II, with the development of radar, sonar, and thermal infrared detection systems. Since the 1960s, sensors have been designed to operate in virtually all of the electromagnetic spectrum. Today a wide variety of remote sensing instruments are available for use in hydrological studies; satellite data, such as Skylab photographs and Landsat images are particularly suitable for regional problems and studies. Planned future satellites will provide a ground resolution of 10–80 m. Remote sensing is currently used for hydrological applications in most countries of the world. The range of applications includes groundwater exploration determination of physical water quality, snowfield mapping, flood-inundation delineation, and making inventories of irrigated land. The use of remote sensing commonly results in considerable hydrological information at minimal cost. This information can be used to speed-up the development of water resources, to improve management practices, and to monitor environmental problems.

Hydrological Sciences Bulletin↗

Satellite remote sensing of water turbidity

Remote sensing instruments obtain an optical measure of water colour and turbidity. Colour increases the absorption of light in water and decreases the remotely sensed signal; turbidity increases the backscatter of light. For low concentrations of suspended materials, spectral reflectance is determined mostly by the absorptance characteristics of water; for higher concentrations, the absorptance characteristics of suspended particles are the most important factors. -from Authorwater colour suspended materials

Hydrological Sciences Bulletin↗

Hydraulics of sheetlike solution cavities

The sheetlike solution cavities that supply water to most wells in central Tennessee are 100 to 2,500 feet wide and less than 0.2 inch high. These dimensions have a scale similar to those in Hele-Shaw models. Both logical and mathematical evidence indicate laminar ground-water flow, except close to pumping wells. The Theis nonequilibrium formula may be used to analyze aquifer-test data and to calculate significant values for transmissivity and storage. The Navier-Stokes equation and the Darcy equation for steady-state conditions may be used to estimate cavity dimensions.

Tennessee↗

ERTS imagery for ground-water investigations

ERTS imagery offers the first opportunity to apply moderately high-resolution satellite data to the nationwide study of water resources. This imagery is both a tool and a form of basic data. Like other tools and basic data, it should be considered for use in ground-water investigations. The main advantage of its use will be to reduce the need for field work. In addition, however, broad regional features may be seen easily on ERTS imagery, whereas they would be difficult or impossible to see on the ground or on low-altitude aerial photographs. Some present and potential uses of ERTS imagery are to locate new aquifers, to study aquifer recharge and discharge, to estimate ground-water pumpage for irrigation, to predict the location and type of aquifer management problems, and to locate and monitor strip mines which commonly are sources for acid mine drainage. In many cases, boundaries which are gradational on the ground appear to be sharp on ERTS imagery. Initial results indicate that the accuracy of maps produced from ERTS imagery is completely adequate for some purposes.

Ground Water↗

Ground-water applications of remote sensing

Remote sensing can be used as a tool to inventory springs and seeps and to interpret lithology, structure, and ground-water occurrence and quality. Thermograms are the best images for inventory of seeps and springs. The steps in aquifer mapping are image analysis and interpretation and ground-water interpretation. A ground-water interpretation is derived from a conceptual geologic model by inferring aquifer characteristics and water salinity. The image selection process is very important for obtaining maximum geologic and hydrologic information from remotely sensed data. Remote sensing can contribute an image base map or geologic and hydrologic parameters, derived from the image, to the multiple data sets in a hydrologic information system. Various merging and integration techniques may then be used to obtain information from these data sets.

Open-File Report↗

Evaluation of radar imagery for geological and cartographic applications

The House/Senate conference report on H.R. 4930 (96th Congress), the Department of the Interior and Related Agencies Appropriations bill, 1980, stated that the U.S. Geological Survey should "begin the use of side-looking airborne radar imagery for topographic and geological mapping, and geological resource surveys in promising areas, particularly Alaska." In response to this mandate, the Survey acquired radar data and began scientific studies to analyze and interpret these data. About 70 percent of the project funding was used to acquire radar imagery and to evaluate Alaskan applications. Results of these studies indicate that radar images have a unique incremental value for certain geologic and cartographic applications but that the images are best suited for use as supplemental information sources or as primary data sources in areas of persistent cloud cover. The value of radar data is greatest for geologic mapping and resource surveys, particularly for mineral and petroleum exploration, where the objective is to locate any single feature or group of features that may control the occurrences of these resources. Radar images are considered by oil and gas companies to be worth the cost of data acquisition within a limited area of active exploration. Radar images also have incremental value for geologic site studies and hazard mapping. The need in these cases is TO inventory all geologic hazards to human life, property, resources, and the environment. For other geologic applications, radar images have a relatively small incremental value over a combination of Landsat images and aerial photographs. The value of radar images for cartographic applications is minimal, except when they are used as a substitute for aerial photographs and topographic maps in persistently cloud-covered areas. If conventional data sources are not available, radar images provide useful information on terrain relief, landforms, drainage patterns, and land cover. Screen less lithography is a low-cost method of reproducing the images. The images from modern, commercially available radar systems have good visual quality; they also have better geometric accuracy and higher information content than images from older systems. Images from modern systems, however, also have some of the same disadvantages as those from older systems. The most serious problem is that considerable information is lost in the process of recording the radar return on film. Another problem is that the oblique radar view of the landscape results in interpretations that are biased by look direction. A compromise antenna depression angle also commonly results in inadequate or excessive shadowing in parts of the image. There is a need for high-resolution digital data, not currently available from the private sector, to significantly improve the utility of radar data for geologic and cartographic applications.

Open-File Report↗

Lineaments on Skylab photographs: detection, mapping and hydrologic significance in central Tennessee

Lineaments were detected on SKYLAB photographs by stereo viewing , projection viewing, and composite viewing. Large well yields of 25 gal/min or more can be obtained in the study area by locating future wells on SKYLAB lineaments rather than on lineaments detected on either high-altitude aerial photographs, LANDSAT images, or by random drilling. Larger savings might be achieved by locating wells on lineaments detected by both stereo viewing and projection. The test site is underlain by dense, fractured, flat-lying limestones. Soil cover averages 4 ft thick in the Central Basin and about 40 ft thick on the Eastern Highland rim. Groundwater occurs mostly in horizontal, sheetlike solution cavities, and the trends of these cavities are controlled by joints. (Lardner-ISWS)

Open-File Report↗

Geology and hydrology of the Claiborne Group in western Tennessee

The area of western Tennessee underlain by the Claiborne Group is about 7,200 square miles and lies on the east flank of the syncline that forms the Mississippi embayment. It includes the Mississippi Alluvial Plain and part of a dissected upland plateau. The Claiborne Group dips to the northwest at 10-25 feet per mile and ranges in altitude from 600 feet above mean sea level in the outcrop area to 900 feet below mean sea level near the embayment axis. The Claiborne Group is tentatively subdivided into five units including, in ascending order, the Meridian Sand Member of the Tallahatta Formation, the Basic City Shale Member of the Tallahatta Formation, the Sparta Sand, an unnamed clay unit, and an unnamed sand unit. The two major aquifers in the Claiborne Group are the '500-foot' sand and the unnamed sand unit. The top of the '500-foot' sand is correlated with the top of the Sparta Sand; and the base, with the base of the Claiborne Group. The '500-foot' sand ranges in thickness from 200 to 750 feet and consists mainly of very fine to coarse sand or gravel. It also contains layers of white to blue, pink, gray, or brown clay, which constitute only a small percentage of the total thickness. The unnamed sand unit ranges from 0 to 210 feet in thickness and consists mostly of white, gray, or brown fine-grained lignitic sand. An estimated 75 percent of the ground water withdrawn in western Tennessee (west of the northward-flowing segment of the Tennessee River) is taken from the '500-foot' sand and the unnamed sand unit. The quantities of water available to wells from the '500-foot' sand are currently adequate for all municipal and industrial needs. The permeability of this aquifer is about 570 gallons per day per square foot. An estimated 155 mgd (million gallons per day) is pumped from the '500-foot' sand, about 140 mgd is discharged from the aquifer as the base flow of surface streams, and about 40 mgd is discharged from the report area as underflow. Water from the '500-foot' sand contains objectionable quantities of iron in the western half of the report area. Otherwise the quality of the water is suitable for most needs. Quantities of water adequate for domestic use and for small municipal systems can be obtained from the unnamed sand unit in most of the report area. The field permeability of this aquifer is probably about 270 gallons per day per square foot. About 8 mgd is discharged into adjacent formations, and about 2 mgd is withdrawn by pumping. Water from the unnamed sand unit contains objectionable quantities of iron in the western half of the report area. Otherwise the water from this aquifer is of good quality. Ground-water supplies in both the '500-foot' sand and the unnamed sand unit will be adequate for the predicted rate of municipal growth and economic development for many years to come. If the hydraulic gradient in the '500-foot' sand were increased to 19 feet per mile, the average dip of the top of the aquifer, about 578 mgd would be transmitted downdip. Similarly, the unnamed sand unit would transmit about 34 mgd downdip under a hydraulic gradient of 10 feet per mile. Furthermore, additional amounts of water could be induced into the report area as underflow from adjacent States. The anticipated effects of additional large scale development are (1) a drop in local and regional water levels in proportion to the increase in pumpage, (2) an increase in the net inflow of ground water from adjacent States, and (3) an increase of recharge to the aquifers at the expense of streamflow.

Water Supply Paper↗