Geology topics

E. Geist

Publications and source records attributed to E. Geist.

5 recordsLinked to original sources

USGS2012

Crustal structure of accreted terranes in southern Alaska, Chugach Mountains and Copper River Basin, from seismic refraction results

Seismic refraction data were collected along a 320-km-long "transect' line in southern Alaska, crossing the Prince William, Chugach, Peninsular, and Wrangellia terranes, and along several shorter lines within individual terranes. Velocity structure in the upper crust (less than 9-km depth) differs among the four terranes. In contrast, layers in the middle crust (9- to 25-km depth) in some case extend across projected terrane boundaries. The top of a gently north dipping sequence of low- and high-velocity layers (5.7-7.8 km/s), more than 10 km thick, extends from near the surface in the southern Chugach terrane to more than 20-km depth beneath the southern Peninsular terrane. This sequence, truncated by the suture between the Prince William and Chugach terranes, is interpreted to be an underplated "terrane' made up of fragments of the Kula plate and its sedimentary overburden that were accreted during subduction in the late Mesozoic and/or early Tertiary, during or between times of accretion of the Prince William and Chugach terranes.

Alaska↗

USGS2009

Geomorphology, stability and mobility of the Currituck slide

Over the last 100,000??years, the U.S. Atlantic continental margin has experienced various types of mass movements some of which are believed to have taken place at times of low sea level. At one of these times of low sea level a significant trigger caused a major submarine mass movement off the coast of Virginia: the Currituck slide which is believed to have taken place between 24 and 50??ka ago. This slide removed a total volume of about 165??km 3 from this section of the continental slope. The departure zone still shows a very clean surface that dips at 4?? and is only covered by a thin veneer of postglacial sediment. Multibeam bathymetric and seismic survey data suggest that this slide took place along three failures surfaces. The morphology of the source area suggests that the sediments were already at least normally consolidated at the time of failure. The slide debris covers an area as much as 55??km wide that extends 180??km from the estimated toe of the original slope. The back analysis of slide initiation indicates that very high pore pressure, a strong earthquake, or both had to be generated to trigger slides on such a low failure plane angle. The shape of the failure plane, the fact that the surface is almost clear of any debris, and the mobility analysis, all support the argument that the slides took place nearly simultaneously. Potential causes for the generation of high pore pressures could be seepage forces from coastal aquifers, delta construction and related pore pressure generation due to the local sediment loading, gas hydrates, and earthquakes. This slide, and its origin, is a spectacular example of the potential threat that submarine mass movements can pose to the US Atlantic coast and underline the need to further assess the potential for the generation of such large slides, like the Grand Banks 1927 landslide of similar volume. ?? 2008 Elsevier B.V.

Marine Geology↗

USGS2003

Source depth dependence of micro-tsunamis recorded with ocean-bottom pressure gauges: The January 28, 2000 Mw 6.8 earthquake off Nemuro Peninsula, Japan

Micro-tsunami waves with a maximum amplitude of 4-6 mm were detected with the ocean-bottom pressure gauges on a cabled deep seafloor observatory south of Hokkaido, Japan, following the January 28, 2000 earthquake (M w 6.8) in the southern Kuril subduction zone. We model the observed micro-tsunami and estimate the focal depth and other source parameters such as fault length and amount of slip using grid searching with the least-squares method. The source depth and stress drop for the January 2000 earthquake are estimated to be 50 km and 7 MPa, respectively, with possible ranges of 45-55 km and 4-13 MPa. Focal depth of typical inter-plate earthquakes in this region ranges from 10 to 20 km and stress drop of inter-plate earthquakes generally is around 3 MPa. The source depth and stress drop estimates suggest that the earthquake was an intra-slab event in the subducting Pacific plate, rather than an inter-plate event. In addition, for a prescribed fault width of 30 km, the fault length is estimated to be 15 km, with possible ranges of 10-20 km, which is the same as the previously determined aftershock distribution. The corresponding estimate for seismic moment is 2.7x10 19 Nm with possible ranges of 2.3x10 19 -3.2x10 19 Nm. Standard tide gauges along the nearby coast did not record any tsunami signal. High-precision ocean-bottom pressure measurements offshore thus make it possible to determine fault parameters of moderate-sized earthquakes in subduction zones using open-ocean tsunami waveforms. Published by Elsevier Science B. V.

Earth and Planetary Science Letters↗

USGS2003

Slip distribution of the 1952 Tokachi-Oki earthquake (M 8.1) along the Kuril Trench deduced from tsunami waveform inversion

We inverted 13 tsunami waveforms recorded in Japan to estimate the slip distribution of the 1952 Tokachi-Oki earthquake (M 8.1), which occurred southeast off Hokkaido along the southern Kuril subduction zone. The previously estimated source area determined from tsunami travel times [Hatori, 1973] did not coincide with the observed aftershock distribution. Our results show that a large amount of slip occurred in the aftershock area east of Hatori's tsunami source area, suggesting that a portion of the interplate thrust near the trench was ruptured by the main shock. We also found more than 5 m of slip along the deeper part of the seismogenic interface, just below the central part of Hatori's tsunami source area. This region, which also has the largest stress drop during the main shock, had few aftershocks. Large tsunami heights on the eastern Hokkaido coast are better explained by the heterogeneous slip model than previous uniform-slip fault models. The total seismic moment is estimated to be 1.87 ?? 1021 N m, giving a moment magnitude of Mw = 8.1. The revised tsunami source area is estimated to be 25.2 ?? 103 km2, ???3 times larger than the previous tsunami source area. Out of four large earthquakes with M ??? 7 that subsequently occurred in and around the rupture area of the 1952 event, three were at the edges of regions with relatively small amount of slip. We also found that a subducted seamount near the edge of the rupture area possibly impeded slip along the plate interface.

Journal of Geophysical Research B: Solid Earth↗

USGS1998

Upper crustal structure and Neogene tectonic development of the California continental borderland

Multichannel seismic-reflection data, sonobuoy seismic-refraction data, and regional geology are used to define the upper crustal structure of the southern California continental borderland and to delineate the characteristics of the main lithotectonic belts of the region. The Catalina Schist belt is separated on its west side from the gently deformed Nicolas forearc belt by faults that have steep west dips and pronounced normal separations. On its east side the schist belt is bounded by a large detachment fault that dips gently to the east beneath the west edge of the Peninsular Ranges belt at the coastline near Oceanside. The Catalina Schist was uplifted from middle crustal depths and exposed during a major event of extensional tectonism that started in early Miocene time in conjunction with about 10° of clockwise rotation of the western Transverse Ranges belt. Part of the uplift of the Catalina Schist could have occurred on the detachment fault, but it is thought to have mostly occurred on the steep faults that bound the west edge of the schist belt. A large amount of uplift is required, and it probably involved strong footwall flexural deformation in the wake of the translating and rotating western Transverse Ranges and Nicolas forearc belts. Extension, accompanied by probable large amounts of right slip, continued in the borderland region during and after middle Miocene time. The later stage of extension was accompanied by rapid clockwise rotation of the western Transverse Ranges of at least 90°. Most of the borderland, including the belt of schist that was uplifted in early Miocene time, was further deformed into numerous basins and ridges during this stage of oblique extension. The primary driving force for the deformation is thought to have been derived from the rapid northwest motion of the Pacific plate after it had become coupled to the Farallon plate system, which had previously been subducted beneath the borderland.

Geological Society of America Bulletin↗