Geology Reports⌕ Search

Geology topics

Douglas F. Scott

Publications and source records attributed to Douglas F. Scott.

12 recordsLinked to original sources
USGS1999

Seismic tomography as a tool for measuring stress in mines

Spokane Research Center personnel have been investigating the use of seismic tomography to monitor the behavior of a rock mass, detect hazardous ground conditions and assess the mechanical integrity of a rock mass affected by mining. Seismic tomography can be a valuable tool for determining relative stress in deep, >1,220-m (>4,000-ft), underground pillars. If high-stress areas are detected, they can be destressed prior to development or they can be avoided. High-stress areas can be monitored with successive seismic surveys to determine if stress decreases to a level where development can be initiated safely. There are several benefits to using seismic tomography to identify high stress in deep underground pillars. The technique is reliable, cost-effective, efficient and noninvasive. Also, investigators can monitor large rock masses, as well as monitor pillars during the mining cycle. By identifying areas of high stress, engineers will be able to assure that miners are working in a safer environment.Spokane Research Center personnel have been investigating the use of seismic tomography to monitor the behavior of a rock mass, detect hazardous ground conditions and assess the mechanical integrity of a rock mass affected by mining. Seismic tomography can be a valuable tool for determining relative stress in deep, >1,200-m (>4,000-ft), underground pillars. If high-stress areas are detected, they can be destressed prior to development or they can be avoided. High-stress areas can be monitored with successive seismic surveys to determine if stress decreases to a level where development can be initiated safely. There are several benefits to using seismic tomography to identify high stress in deep underground pillars. The technique is reliable, cost-effective, efficient and noninvasive. Also, investigators can monitor large rock masses, as well as monitor pillars during the mining cycle. By identifying areas of high stress. engineers will be able to assure that miners are working in a safer environment.

Mining Engineering↗
USGS1982

Mineral resource potential map of the Mokelumne Wilderness and contiguous roadless areas, central Sierra Nevada, California

Under the provisions of the Wilderness Act (Public Law 88-577, September 3, 1964) and the Joint Conference Report on Senate Bill 4, 88th Congress, the U.S. Geological Survey and the U.S. Bureau of Mines have been conducting mineral surveys of wilderness and primitive areas. Areas officially designated as "wilderness," "wild," or "canoe" when the act was passed were incorporated into the National Wilderness Preservation System, and some of them are presently being studied. The act provided that areas under consideration for wilderness designation should be studied for suitability for incorporation into the Wilderness System. The mineral surveys constitute one aspect of suitability studies. The act directs that the results of such surveys are to be made available to the public and be submitted to the President and the Congress. This report discusses the results of a mineral survey of the Mokelumne Wilderness, El Dorado National Forest, Amador, Calaveras and Alpine Counties, California and Caples Creek, Raymond Peak, and Tragedy-Elephants Back Roadless Areas, Alpine, Amador, Ca 1 aver as, and El Dorado Counties, California. The Mokelumne Wilderness was established by Public Law 88-577, September 3, 1964, the Roadless Areas were classified as further planning areas during the Second Roadless Area Review and Evaluation (RARE II) by the U.S. Forest Service, 1979.

California↗
USGS1982

Mineral resource potential of the Granite Chief Wilderness Study Area, Placer County, California

A mineral resource survey of the Granite Chief Wilderness Study Area in the Tahoe National Forest and Lake Tahoe Management Area was conducted between 1979 and 1981. The mineral resource potential of the area was evaluated from geologic and geochemical studies by the U.S. Geological Survey, and from the examination of existing published and unpublished records of mining prospects and field examination of prospects, mineralized rocks, and placer deposits by the U.S. Bureau of Mines. These investigations indicate that the study area has a low potential for mineral resources. Analyses of samples taken from prospect pits, altered outcrops, and stream-sediment samples indicate no minable quantities of precious or base metals. Placer deposits are too small and too low in grade to be considered a resource. Substantial deposits of sand, gravel, and glacial till suitable for construction materials occur within the area, but their inaccessibility and remoteness from major markets preclude their being classified as a resource. No potential for oil, gas, coal, or geothermal resources was identified.

California↗