Geology topics

Dean E. Anderson

Publications and source records attributed to Dean E. Anderson.

7 recordsLinked to original sources

USGS2021

Estimates of energy partitioning, evapotranspiration, and net ecosystem exchange of CO2 for an urban lawn and a tallgrass prairie in the Denver metropolitan area under contrasting conditions

Lawns as a landcover change substantially alter evapotranspiration, CO 2 , and energy exchanges and are of rising importance considering their spatial extent. We contrast eddy covariance (EC) flux measurements collected in the Denver, Colorado, USA metropolitan area in 2011 and 2012 over a lawn and a xeric tallgrass prairie. Close linkages between seasonal vegetation development, energy fluxes, and net ecosystem exchange ( NEE ) of CO 2 were found. Irrigation of the lawn modified energy and CO 2 fluxes and greatly contributed to differences observed between sites. Due to greater water inputs (precipitation + irrigation) at the lawn in this semi-arid climate, energy partitioning at the lawn was dominated by latent heat ( LE ) flux. As a result, evapotranspiration ( ET ) of the lawn was more than double that of tallgrass prairie (2011: 639(±17) mm vs. 302(±9) mm; 2012: 584(±15) mm vs. 265(±7) mm). NEE for the lawn was characterized by a longer growing season, higher daily net uptake of CO 2 , and growing season NEE that was also more than twice that of the prairie (2011: −173(±23) g C m −2 vs. -81(±10) g C m −2 ; 2012: −73(±22) g C m −2 vs. -21(±8) g C m −2 ). During the drought year (2012), temperature and water stress greatly influenced the direction and magnitude of CO 2 flux at both sites. The results suggest that lawns in Denver can function as carbon sinks and conditionally contribute to the mitigation of carbon emissions - directly by CO 2 uptake and indirectly through effects of evaporative cooling on microclimate and energy use.

Colorado↗

USGS2010

Atmospheric stability effects on wind fields and scalar mixing within and just above a subalpine forest in sloping terrain

Air temperature T a , specific humidity q , CO 2 mole fraction χ c , and three-dimensional winds were measured in mountainous terrain from five tall towers within a 1 km region encompassing a wide range of canopy densities. The measurements were sorted by a bulk Richardson number Ri b . For stable conditions, we found vertical scalar differences developed over a “transition” region between 0.05 < Ri b < 0.5. For strongly stable conditions ( Ri b > 1), the vertical scalar differences reached a maximum and remained fairly constant with increasing stability. The relationships q and χ c have with Ri b are explained by considering their sources and sinks. For winds, the strong momentum absorption in the upper canopy allows the canopy sublayer to be influenced by pressure gradient forces and terrain effects that lead to complex subcanopy flow patterns. At the dense-canopy sites, soil respiration coupled with wind-sheltering resulted in CO 2 near the ground being 5–7 μmol mol −1 larger than aloft, even with strong above-canopy winds (near-neutral conditions). We found Ri b -binning to be a useful tool for evaluating vertical scalar mixing; however, additional information (e.g., pressure gradients, detailed vegetation/topography, etc.) is needed to fully explain the subcanopy wind patterns. Implications of our results for CO 2 advection over heterogenous, complex terrain are discussed.

Boundary-Layer Meteorology↗

USGS2008

Canopy structure and atmospheric flows in relation to the δ13C of respired CO 2 in a subalpine coniferous forest

Stable isotopes provide insight into ecosystem carbon cycling, plant physiological processes, atmospheric boundary-layer dynamics, and are useful for the integration of processes over multiple scales. Of particular interest is the carbon isotope content (δ 13 C) of nocturnal ecosystem-respired CO 2 ( δ R ). Recent advances in technology have made it possible to continuously examine the variation in δ R within a forest canopy over relatively long time-scales (months–years). We used tunable diode laser spectroscopy to examine δ R at within- and below-canopy spatial locations in a Colorado subalpine forest (the Niwot Ridge AmeriFlux site). We found a systematic pattern of increased δ R within the forest canopy ( δ R-c ) compared to that near the ground ( δ R-g ). Values of δ R-c were weakly correlated with the previous day's mean maximum daytime vapor pressure deficit (VPD). Conversely, there was a negative but still weak correlation between δ R-g and time-lagged (0–5 days) daily mean soil moisture. The topography and presence of sustained nightly drainage flows at the Niwot Ridge forest site suggests that, on nights with stable atmospheric conditions, there is little mixing of air near the ground with that in the canopy. Atmospheric stability was assessed using thresholds of friction velocity, stability above the canopy, and bulk Richardson number within the canopy. When we selectively calculated δ R-g and δ R-c by removing time periods when ground and canopy air were well mixed, we found stronger correlations between δ R-c and VPD, and δ R-g and soil moisture. This suggests that there may be fundamental differences in the environmental controls on δ R at sub-canopy spatial scales. These results may help explain the wide variance observed in the correlation of δ R with different environmental parameters in other studies.

Colorado↗

USGS2003

Airflows and turbulent flux measurements in mountainous terrain: Part 1. Canopy and local effects

We have studied the effects of local topography and canopy structure on turbulent flux measurements at a site located in mountainous terrain within a subalpine, coniferous forest. Our primary aim was to determine whether the complex terrain of the site affects the accuracy of eddy flux measurements from a practical perspective. We observed displacement heights, roughness lengths, spectral peaks, turbulent length scales, and profiles of turbulent intensities that were comparable in magnitude and pattern to those reported for forest canopies in simpler terrain. We conclude that in many of these statistical measures, the local canopy exerts considerably more influence than does topographical complexity. Lack of vertical flux divergence and modeling suggests that the flux footprints for the site are within the standards acceptable for the application of flux statistics. We investigated three different methods of coordinate rotation: double rotation (DR), triple rotation (TR), and planar-fit rotation (PF). Significant variability in rotation angles at low wind speeds was encountered with the commonly used DR and TR methods, as opposed to the PF method, causing some overestimation of the fluxes. However, these differences in fluxes were small when applied to large datasets involving sensible heat and CO 2 fluxes. We observed evidence of frequent drainage flows near the ground during stable, stratified conditions at night. Concurrent with the appearance of these flows, we observed a positive bias in the mean vertical wind speed, presumably due to subtle topographic variations inducing a flow convergence below the measurement sensors. In the presence of such drainage flows, advection of scalars and non-zero bias in the mean vertical wind speed can complicate closure of the mass conservation budget at the site.

Agricultural and Forest Meteorology↗

USGS2001

Eddy covariance measurement of CO2 flux to the atmosphere from a area of high volcanogenic emissions, Mammoth Mountain, California

Three pilot studies were performed to assess application of the eddy covariance micrometeorological method in the measurement of carbon dioxide (CO 2 ) flux of volcanic origin. The selected study area is one of high diffuse CO 2 emission on Mammoth Mountain, CA. Because terrain and source characteristics make this a complex setting for this type of measurement, added consideration was given to source area and upwind fetch. Footprint analysis suggests that the eddy covariance measurements were representative of an upwind elliptical source area (3.8×10 3 m 2 ) which can vary with mean wind direction, surface roughness, and atmospheric stability. CO 2 flux averaged 8–16 mg m −2 s −1 (0.7–1.4 kg m −2 day −1 ). Eddy covariance measurements of flux were compared with surface chamber measurements made in separate studies [Geophys. Res. Lett. 25 (1998a) 1947; EOS Trans. 79 (1998) F941.] and were found to be similar.

Chemical Geology↗

USGS1995

A Lagrangian stochastic model for aerial spray transport above an oak forest

An aerial spray droplets' transport model has been developed by applying recent advances in Lagrangian stochastic simulation of heavy particles. A two-dimensional Lagrangian stochastic model was adopted to simulate the spray droplet dispersion in atmospheric turbulence by adjusting the Lagrangian integral time scale along the drop trajectory. The other major physical processes affecting the transport of spray droplets above a forest canopy, the aircraft wingtip vortices and the droplet evaporation, were also included in each time step of the droplets' transport. The model was evaluated using data from an aerial spray field experiment. In generally neutral stability conditions, the accuracy of the model predictions varied from run-to-run as expected. The average root-mean-square error was 24.61 IU cm −2 , and the average relative error was 15%. The model prediction was adequate in two-dimensional steady wind conditions, but was less accurate in variable wind condition. The results indicated that the model can simulate successfully the ensemble; average transport of aerial spray droplets under neutral, steady atmospheric wind conditions.

Agricultural and Forest Meteorology↗

USGS1992

Deposition of aerially applied BT in an oak forest and its prediction with the FSCBG model

Data are provided from 17 single-swath aerial spray trials that were conducted over a fully leafed, 16-m tall, mixed oak forest. The distribution of cross-swath spray deposits was sampled at the top of the canopy and below the canopy. Micrometeorological conditions were measured above and within the canopy during the spray trials. The USDA Forest Service FSCBG (Forest Service-Cramer-Barry-Grim) model was run to predict the target sampler catch for each trial using forest stand, airplane-application-equipment configuration, and micrometeorological conditions as inputs. Observations showed an average cross-swath deposition of 100 IU cm −2 with large run-to-run variability in deposition patterns, magnitudes, and drift. Eleven percent of the spray material that reached the top of the canopy penetrated through the tree canopy to the forest floor. The FSCBG predictions of the ensemble-averaged deposition were within 17% of the measured deposition at the canopy top and within 8% on the ground beneath the canopy. Run-to-run deposit predictions by FSCBG were considerably less variable than the measured deposits. Individual run predictions were much less accurate than the ensemble-averaged predictions as demonstrated by an average root-mean-square-error (rmse) of 27.9 IU CM −2 at the top of the canopy. Comparisons of the differences between predicted and observed deposits indicated that the model accuracy was sensitive to atmospheric stability conditions. In neutral and stable conditions, a regular pattern of error was indicated by overprediction of the canopy-top deposit at distances from 0 to 20 m downwind from the flight line and underprediction of the deposit both farther downwind than 20 m and upwind of the flight line. In unstable conditions the model generally underpredicted the deposit downwind from the flight line, but showed no regular pattern of error.

Journal of Applied Meteorology↗