Geology topics

Darryl E. Granger

Publications and source records attributed to Darryl E. Granger.

9 recordsLinked to original sources

USGS2025

Two million years of climate-driven cave-sediment aggradation and valley incision in the southern Ozark Plateau from Fitton Cave, northern Arkansas, USA

Landscape evolution in karst terrains affects both subterranean and surface settings. For better understanding of controlling processes and connections between the two, multiple geochronometers were used to date sediments and speleothems in upper-level passages of Fitton Cave adjacent to the Buffalo River, northern Arkansas, within the southern Ozark Plateau. Burial cosmogenic-nuclide dating of coarse sediments indicates that gravel pulses washed into upper passages at 2.2 Ma and 1.25 Ma. These represent the oldest epigenetic cave deposits documented in this region. Associated sands and clay-rich sediments mostly have reversed magnetic polarity and thermally transferred optically stimulated luminescence dates of 1.2 to 1.0 Ma. Abandonment of these upper passages began before 0.72 Ma, when coarse sediment was deposited in a passage incised below older sediment. Maximum U-series dates of 0.7–0.4 Ma for flowstones capping clastic deposits mark the stabilization of older sediments and a change to vadose conditions that allowed post–0.4 Ma stalagmite growth. Resulting valley incision rates since 0.85 Ma are estimated at 27 m/Ma. Coarse cave-sediment pulses correlate to Laurentide glacial tills about 300 km to the north, suggesting climate influence on periglacial sediment production. Dated cave sediments also may correlate with undated older strath terraces preserved at similar heights above the Buffalo River.

Arkansas↗

USGS2025

Measurement of in situ-produced cosmogenic nuclides in fine-grained quartz from shale

In situ -produced 10 Be in quartz is widely used to constrain exposure ages and denudation rates, traditionally measured in sand-sized grains. Here we report a new method for isolating fine-grained quartz from shale and demonstrate its reliability for grain sizes down to single microns. Sequential dissolution tests and analyses of grain size separates show that meteoric 10 Be is eliminated and that recoil losses during cosmogenic nuclide production are balanced by implantation from other mineral grains. High-temperature combustion leads to diffusion of meteoric 10 Be into fine-grained quartz and must be used with caution.

Nuclear Instruments and Methods in Physics Researc↗

USGS2025

10Be/9Be and 26Al/10Be support a late Miocene burial age for basal Gray Fossil Site sediments

We provide 2 independent radioisotopic age estimates for cored basal sediments of the Gray Fossil Site using cosmogenic nuclides. The first estimate uses meteoric 10 Be/ 9 Be from the bottom of the GFS-1 core, as well as from modern local grasses, to constrain the deposition of basal GFS sinkhole complex sediments to 6.60 ± 0.85 Ma. We corroborated this age estimate using in-situ 10 Be and 26 Al in quartz sands from the GFS-1 core. This estimate provided a looser constraint than the 10 Be met / 9 Be approach, yielding a minimum burial age for the basal sediments of 4.43 ± 0.34 Ma. These independent geochronometers provide evidence that the deepest GFS sediments are at least early Pliocene in age, and likely date to the late Miocene.

Tennessee↗

USGS2022

The Pliocene-to-present course of the Tennessee River

The Tennessee River, a primary drainage of the southern Appalachians and significant sediment source for the Gulf of Mexico, is generally considered to be the product of captures that rerouted the river from a more direct gulfward course. Sedimentary and genetic evidence indicates that a paleo-Tennessee flowed into the Mobile Basin through the late Miocene, although alternate models propose other redirections of the river. We constrain the river course’s age by dating terraces near Pickwick, Tennessee, with cosmogenic 26 Al/ 10 Be isochron burial dating. We find that the river’s present path dates to at least the early Pliocene.

Tennessee↗

USGS2014

Steady incision of Grand Canyon at the million year timeframe: A case for mantle-driven differential uplift

The Grand Canyon region provides an excellent laboratory to examine the interplay between river incision, magmatism, and the geomorphic and tectonic processes that shape landscapes. Here we apply U-series, Ar–Ar, and cosmogenic burial dating of river terraces to examine spatial variations in incision rates along the 445 km length of the Colorado River through Grand Canyon. We also analyze strath terrace sequences that extend to heights of several hundred meters above the river, and integrate these with speleothem constrained maximum incision rates in several reaches to examine any temporal incision variations at the million-year time frame. This new high-resolution geochronology shows temporally steady long-term incision in any given reach of Grand Canyon but significant variations along its length from 160 m/Ma in the east to 101 m/Ma in the west. Spatial and temporal patterns of incision, and the long timescale of steady incision rule out models where geomorphic controls such as climate oscillations, bedrock strength, sediment load effects, or isostatic response to differential denudation are the first order drivers of canyon incision. The incision pattern is best explained by a model of Neogene and ongoing epeirogenic uplift due to an eastward propagating zone of increased upper mantle buoyancy that we infer from propagation of Neogene basaltic volcanism and a strong lateral gradient in modern upper mantle seismic structure.

Arizona↗

USGS2014

Distinguishing between tectonic and lithologic controls on bedrock channel longitudinal profiles using cosmogenic 10Be erosion rates and channel steepness index

Knickpoints in fluvial channel longitudinal profiles and channel steepness index values derived from digital elevation data can be used to detect tectonic structures and infer spatial patterns of uplift. However, changes in lithologic resistance to channel incision can also influence the morphology of longitudinal profiles. We compare the spatial patterns of both channel steepness index and cosmogenic 10 Be-determined erosion rates from four landscapes in Italy, where the geology and tectonics are well constrained, to four theoretical predictions of channel morphologies, which can be interpreted as the result of primarily tectonic or lithologic controls. These data indicate that longitudinal profile forms controlled by unsteady or nonuniform tectonics can be distinguished from those controlled by nonuniform lithologic resistance. In each landscape the distribution of channel steepness index and erosion rates is consistent with model predictions and demonstrates that cosmogenic nuclide methods can be applied to distinguish between these two controlling factors.

Geomorphology↗

USGS2012

Uplift history of the Sila Massif, southern Italy, deciphered from cosmogenic 10 Be erosion rates and river longitudinal profile analysis

The Sila Massif in the Calabrian Arc (southern Italy) is a key site to study the response of a landscape to rock uplift. Here an uplift rate of ∼1 mm/yr has imparted a deep imprint on the Sila landscape recorded by a high-standing low-relief surface on top of the massif, deeply incised fluvial valleys along its flanks, and flights of marine terraces in the coastal belt. In this framework, we combined river longitudinal profile analysis with hillslope erosion rates calculated by 10 Be content in modern fluvial sediments to reconstruct the long-term uplift history of the massif. Cosmogenic data show a large variation in erosion rates, marking two main domains. The samples collected in the high-standing low-relief surface atop Sila provide low erosion rates (from 0.09 ± 0.01 to 0.13 ± 0.01 mm/yr). Conversely, high values of erosion rate (up to 0.92 ± 0.08 mm/yr) characterize the incised fluvial valleys on the massif flanks. The analyzed river profiles exhibit a wide range of shapes diverging from the commonly accepted equilibrium concave-up form. Generally, the studied river profiles show two or, more frequently, three concave-up segments bounded by knickpoints and characterized by different values of concavity and steepness indices. The wide variation in cosmogenic erosion rates and the non-equilibrated river profiles indicate that the Sila landscape is in a transient state of disequilibrium in response to a strong and unsteady uplift not yet counterbalanced by erosion.

Sila Massif↗

USGS2011

Dating of Pliocene Colorado River sediments: implications for cosmogenic burial dating and the evolution of the lower Colorado River

We applied cosmogenic 26 Al/ 10 Be burial dating to sedimentary deposits of the ancestral Colorado River. We compared cosmogenic burial ages of sediments to the age of an independently well-dated overlying basalt flow at one site, and also applied cosmogenic burial dating to sediments with less precise independent age constraints. All dated gravels yielded old ages that suggest several episodes of sediment burial over the past ∼5.3 m.y. Comparison of burial ages to the overlying 4.4 Ma basalt yielded good agreement and suggests that under the most favorable conditions, cosmogenic burial dating can extend back 4–5 m.y. In contrast, results from other sites with more broadly independent age constraints highlight the complexities inherent in burial dating; these complexities arise from unknown and complicated burial histories, insufficient shielding, postburial production of cosmogenic isotopes by muons, and unknown initial 26 Al/ 10 Be ratios. Nevertheless, and in spite of the large range of burial ages and large uncertainties, we identify samples that provide reasonable burial age constraints on the depositional history of sediment along the lower ancestral Colorado River. These samples suggest possible sediment deposition and burial at ca. 5.3, 4.7, and 3.6 Ma. Our calculated basinwide erosion rate for sediment transported by the modern Colorado River (∼187 mm k.y. −1 ) is higher than the modern erosion rates inferred from the historic sediment load (80–100 mm k.y. −1 ). In contrast, basinwide paleo-erosion rates calculated from Pliocene sediments are all under 40 mm k.y. −1 The comparatively lower denudation rates calculated for the Pliocene sediment samples are surprising given that the sampled time intervals include significant Pliocene aggradation and may include much incision of the Grand Canyon and its tributaries. This conflict may arise from extensive storage of sediment along the route of the Colorado River, slower paleobedrock erosion, or the inclusion of sediments that were derived preferentially from higher elevations in the watershed.

Geological Society of America Bulletin↗

USGS2010

Quantifying rock uplift rates using channel steepness and cosmogenic nuclide–determined erosion rates: Examples from northern and southern Italy

Rock uplift rates can be difficult to measure over 10 3 –10 5 yr time scales. If, however, a landscape approaches steady state, where hillslope erosion and rock uplift rates are steady and locally similar, then it should be possible to quantify rock uplift rates from hillslope erosion rates. Here, we test this prediction by comparing channel steepness index values and 10 Be catchment-averaged erosion rates to well-constrained rock uplift rates in two landscapes in Italy. The first field area is the Romagna Apennines, northern Italy, where rock uplift rates are relatively uniform, between 0.2 and 0.5 mm/yr (regional mean 0.40 ± 0.15 [SE] mm/yr), and have been steady since 0.9 Ma. The second area is the region around northeastern Sicily and the southernmost Italian peninsula, where rock uplift rates are higher and exhibit a strong spatial gradient, from ∼0.7 to ∼1.6 mm/yr (regional mean 1.09 ± 0.13 [SE] mm/yr). In both regions, channel steepness indices and 10 Be erosion rates vary directly with rock uplift rates. Although there is considerable variability in erosion rates, regionally averaged rates in both the northern (0.46 ± 0.04 [SE] mm/yr) and southern (1.21 ± 0.24 [SE] mm/yr) areas accurately measure rock uplift rates. Although channel steepness indices do not quantify rock uplift rates, they are useful for (1) identifying regional patterns of rock uplift, (2) identifying areas where uplift rates might be expected to be uniform, and (3) informing 10 Be sampling strategies. This study demonstrates that, together, channel steepness and hillslope erosion rates can provide a powerful tool for determining rock uplift rates.

Lithosphere↗