Geology topics

D.M. Borrok

Publications and source records attributed to D.M. Borrok.

3 recordsLinked to original sources

USGS2010

Zinc isotopic composition of particulate matter generated during the combustion of coal and coal + tire-derived fuels

Atmospheric Zn emissions from the burning of coal and tire-derived fuel (TDF) for power generation can be considerable. In an effort to lay the foundation for tracking these contributions, we evaluated the Zn isotopes of coal, a mixture of 95 wt % coal + 5 wt % TDF, and the particulate matter (PM) derived from their combustion in a power-generating plant. The average Zn concentrations and δ(66)Zn were 36 mg/kg and 183 mg/kg and +0.24‰ and +0.13‰ for the coal and coal + TDF, respectively. The δ(66)Zn of the PM sequestered in the cyclone-type mechanical separator was the lightest measured, -0.48‰ for coal and -0.81‰ for coal+TDF. The δ(66)Zn of the PM from the electrostatic precipitator showed a slight enrichment in the heavier Zn isotopes relative to the starting material. PM collected from the stack had the heaviest δ(66)Zn in the system, +0.63‰ and +0.50‰ for the coal and coal + TDF, respectively. Initial fractionation during the generation of a Zn-rich vapor is followed by temperature-dependent fractionation as Zn condenses onto the PM. The isotopic changes of the two fuel types are similar, suggesting that their inherent chemical differences have only a secondary impact on the isotopic fractionation process.

Environmental Science & Technology↗

USGS2010

Influence of sulfur-bearing polyatomic species on high precision measurements of Cu isotopic composition

An increased interest in high precision Cu isotope ratio measurements using multi-collector inductively coupled plasma mass spectrometry (MC-ICP-MS) has developed recently for various natural geologic systems and environmental applications, these typically contain high concentrations of sulfur, particularly in the form of sulfate (SO 4 2- ) and sulfide (S). For example, Cu, Fe, and Zn concentrations in acid mine drainage (AMD) can range from 100??g/L to greater than 50mg/L with sulfur species concentrations reaching greater than 1000mg/L. Routine separation of Cu, Fe and Zn from AMD, Cu-sulfide minerals and other geological matrices usually incorporates single anion exchange resin column chromatography for metal separation. During chromatographic separation, variable breakthrough of SO 4 2- during anion exchange resin column chromatography into the Cu fractions was observed as a function of the initial sulfur to Cu ratio, column properties, and the sample matrix. SO 4 2- present in the Cu fraction can form a polyatomic 32 S- 14 N- 16 O- 1 H species causing a direct mass interference with 63 Cu and producing artificially light ?? 65 Cu values. Here we report the extent of the mass interference caused by SO 4 2- breakthrough when measuring ?? 65 Cu on natural samples and NIST SRM 976 Cu isotope spiked with SO 4 2- after both single anion column chromatography and double anion column chromatography. A set of five 100??g/L Cu SRM 976 samples spiked with 500mg/L SO 4 2- resulted in an average ?? 65 Cu of -3.50?????5.42??? following single anion column separation with variable SO 4 2- breakthrough but an average concentration of 770??g/L. Following double anion column separation, the average SO 4 2- concentration of 13??g/L resulted in better precision and accuracy for the measured ?? 65 Cu value of 0.01?????0.02??? relative to the expected 0??? for SRM 976. We conclude that attention to SO 4 2- breakthrough on sulfur-rich samples is necessary for accurate and precise measurements of ?? 65 Cu and may require the use of a double ion exchange column procedure. ?? 2010.

Chemical Geology↗

USGS2009

Application of iron and zinc isotopes to track the sources and mechanisms of metal loading in a mountain watershed

Here the hydrogeochemical constraints of a tracer dilution study are combined with Fe and Zn isotopic measurements to pinpoint metal loading sources and attenuation mechanisms in an alpine watershed impacted by acid mine drainage. In the tested mountain catchment, δ 56 Fe and δ 66 Zn isotopic signatures of filtered stream water samples varied by ∼3.5‰ and 0.4‰, respectively. The inherent differences in the aqueous geochemistry of Fe and Zn provided complimentary isotopic information. For example, variations in δ 56 Fe were linked to redox and precipitation reactions occurring in the stream, while changes in δ 66 Zn were indicative of conservative mixing of different Zn sources. Fen environments contributed distinctively light dissolved Fe (<−2.0‰) and isotopically heavy suspended Fe precipitates to the watershed, while Zn from the fen was isotopically heavy (>+0.4‰). Acidic drainage from mine wastes contributed heavier dissolved Fe (∼+0.5‰) and lighter Zn (∼+0.2‰) isotopes relative to the fen. Upwelling of Fe-rich groundwater near the mouth of the catchment was the major source of Fe ( δ 56 Fe ∼ 0‰) leaving the watershed in surface flow, while runoff from mining wastes was the major source of Zn. The results suggest that given a strong framework for interpretation, Fe and Zn isotopes are useful tools for identifying and tracking metal sources and attenuation mechanisms in mountain watersheds.

Applied Geochemistry↗