Geology Reports⌕ Search

Geology topics

D. S. Miller

Publications and source records attributed to D. S. Miller.

7 recordsLinked to original sources
USGS1998

Frequency of effective wave activity and the recession of coastal bluffs: Calvert Cliffs, Maryland

The Calvert Cliffs, Chesapeake Bay, Maryland, USA, erode by direct wave undercutting or by freeze/thaw erosion accompanied by wave removal of slope debris. Directly undercut slopes recede more rapidly, with long-term rates exceeding 1.0 m/yr; freeze/thaw slopes recede at rates approaching 0.5 m/yr. The frequency of wave height and water level at the shoreline is estimated for eleven sites based on a 37-year wind record, estimates of storm surge, offshore wave geometry, nearshore wave transformation, and breaking wave type. Locations experiencing the largest slope recession are not uniformly those with the largest cumulative wave energy; the resistance to erosion of the slope toe must also be accounted for. An index of relative wave strength is defined as the ratio of wave pressure T and the cohesive strength S of the slope material. For the Calvert Cliffs, a minimum relative wave strength for initiating erosion of intact material is 0.05 < T/S < 0.1. A cumulative duration of ???50 hours per year for T/S ??? 0.1 distinguishes undercut and nonundercut slopes and recession rates greater or lesser than 0.5 m/yr. The relative wave strength index may be used to identify sites at risk of increased erosion. At one site with a small historical erosion rate, the loss of a protective beach and associated decrease in toe elevation caused a positive shift in the frequency of large T/S. Direct wave undercutting and increased slope recession may be anticipated at this site, as indicated by the development of an undercut notch during the course of the study.

Journal of Coastal Research↗
USGS1996

Constraints on the thermal history of Taylorsville Basin, Virginia, U.S.A., from fluid-inclusion and fission-track analyses: Implications for subsurface geomicrobiology experiments

Microbial populations have been found at the depth of 2621-2804 m in a borehole near the center of Triassic Taylorsville Basin, Virginia. To constrain possible scenarios for long-term survival in or introduction of these microbial populations to the deep subsurface, we attempted to refine models of thermal and burial history of the basin by analyzing aqueous and gaseous fluid inclusions in calcite/quartz veins or cements in cuttings from the same borehole. These results are complemented by fission-track data from the adjacent boreholes. Homogenization temperatures of secondary aqueous fluid inclusions range from 120?? to 210??C between 2027- and 3069-m depth, with highest temperatures in the deepest samples. The salinities of these aqueous inclusions range from 0 to ??? 4.3 eq wt% NaCl. Four samples from the depth between 2413 and 2931 m contain both two-phase aqueous and one-phase methane-rich inclusions in healed microcracks. The relative CH4 and CO2 contents of these gaseous inclusions was estimated by microthermometry and laser Raman spectroscopy. If both types of inclusions in sample 2931 m were trapped simultaneously, the density of the methane-rich inclusions calculated from the Peng - Robinson equation of state implies an entrapment pressure of 360 ?? 20 bar at the homogenization temperature (162.5 ?? 12.5??C) of the aqueous inclusions. This pressure falls between the hydrostatic and lithostatic pressures at the present depth 2931 m of burial. If we assume that the pressure regime was hydrostatic at the time of trapping, then the inclusions were trapped at 3.6 km in a thermal gradient of ??? 40??C/km. The high temperatures recorded by the secondary aqueous inclusions are consistent with the pervasive resetting of zircon and apatite fission-track dates. In order to fit the fission-track length distributions of the apatite data, however, a cooling rate of 1-2??C/Ma following the thermal maximum is required. To match the integrated dates, the thermal maximum would have occurred at ??? 200 Ma. The timing of the maximum temperature is consistent with rapid burial of the Taylorsville Basin to twice its present-day depth and thermal re-equilibration with a 40??C/km geothermal gradient, followed by slow exhumation. The results may imply that the microorganisms did not survive in situ, but were transported from the cooler portions of the basin sometime after maximum burial and heating.

Chemical Geology↗
USGS1994

Declines in organochlorines in eggs of red-breasted mergansers from Lake Michigan, 1977-78 versus 1990

From 1977–1978 to 1990, concentrations of polychlorinated biphenyls (PCBs) and most organochlorine pesticides declined in eggs of red-breasted mergansers ( Mergus serrator ) nesting on islands in northwestern Lake Michigan. Total PCBs decreased 60% (from 21 ppm in 1977–1978 to 8.5 ppm in 1990) and p,p ′-DDE decreased 66% (from 6.5 to 2.2 ppm). Dieldrin decreased only 16% (from 0.82 to 0.69 ppm). In 1990, 79.1% of incubated eggs hatched, which was not significantly different from the 83.5% that hatched in 1977–1978.

Environmental Monitoring and Assessment↗
USGS1993

Possible secondary apatite fission track age standard from altered volcanic ash beds in the middle Jurassic Carmel Formation, Southwestern Utah

Secondary age standards are valuable in intra- and interlaboratory calibration. At present very few such standards are available for fission track dating that is older than Tertiary. Several altered volcanic ash beds occur in the Middle Jurassic Carmel Formation in southwestern Utah. The formation was deposited in a shallow marine/sabhka environment. Near Gunlock, Utah, eight ash beds have been identified. Sanidines from one of the ash beds (GUN-F) give a single-crystal laser-probe 40Ar/39Ar age of 166.3??0.8 Ma (2??). Apatite and zircon fission track ages range from 152-185 Ma with typically 15-20 Ma errors (2??). Track densities in zircons are high and most grains are not countable. Apatites are fairly common in most of the ash beds and have reasonable track densities ranging between 1.2-1.5 ?? 106 tracks/cm2. Track length distributions in apatites are unimodal, have standard deviations <1??m, and mean track lengths of about 14-14.5 ??m. High Cl apatites (F:Cl:OH ratio of 39:33:28) are particularly abundant and large in ash GUN-F, and are fairly easy to concentrate, but the concentrates contain some siderite, most of which can be removed by sieving. GUN-F shows evidence of some reworking and detriaal contamination based on older single grain 40Ar/39Ar analyses and some rounding of grains, but the apatite population appears to be largely uncontaminated. At present BJK has approximately 12 of apatite separate from GUN-F. ?? 1993.

Nuclear Tracks and Radiation Measurements↗
USGS1985

Short-term velocity measurements at Columbia Glacier, Alaska: August-September 1984

Ice velocity data are presented for the lower reach of Columbia Glacier, Alaska. The data span a 29 day period and contain 1,072 angle sightings from two survey stations to 22 markers placed on the ice surface, and 1,621 laser measurements of the distance to one of those markers (number 11) from another station. These short-interval observations were made to investigate the dynamics of the glacier and to provide input to models for estimation of future retreat and iceberg discharge. The mean ice velocity (at marker number 11) was approximately 9 m/day and ranged from 8 to < 15 m/day. The data set includes a well defined 2-day, 50% velocity increase and a clear pattern of velocity fluctuations of about 5% with approximately diurnal and semiurnal periods. (Author 's abstract)

Alaska↗