Geology Reports⌕ Search

Geology topics

D. R. Hutchinson

Publications and source records attributed to D. R. Hutchinson.

35 records · Page 2Linked to original sources
USGS1996

Amplitude blanking in seismic profiles from Lake Baikal

Imaging of the deepest sedimentary section in Lake Baikal using multichannel seismic profiling was hampered by amplitude blanking that is regionally extensive, is associated with water depths greater than about 900 m and occurs at sub-bottom depths of 1-2 km in association with the first water-bottom multiple. Application of a powerful multiple suppression technique improved the quality of occasional discontinuous, dipping primary reflections, but failed to substantially alter the non-reflective character of the blanking zone. Detailed analysis of amplitudes from original data and synthetic models show that the threshold for detecting primary energy in deep water of Lake Baikal occurs when the primary is about 14-20 dB less than the multiple energy. The blanking occurs because of anomalously low reflectivities of the deep sediments coupled with this 20 dB limitation in real data processing. The blanking cuts across seismic stratal boundaries, and is therefore probably unrelated to depositional lithologies. The deepest, early rift deposits, inferred to come from a mixed fluvial and lacustrine setting, do not easily explain the widespread and uniform character of the blanked deposits. More likely, blanking occurs because of processes or phenomena that physically alter the deposits, causing them to be non-reflective and/or highly attenuating. No single process explains all the observations, but a combination of diagenesis, overpressure, and the presence of dispersed free gas at sub-bottom depths of 1-2 km, offer plausible and possible conditions that contribute to blanking. Copyright ?? 1996 Published by Elsevier Science Ltd.

Marine and Petroleum Geology↗
USGS1992

Depositional and tectonic framework of the rift basins of Lake Baikal from multichannel seismic data

Recent multichannel seismic reflection data from Lake Baikal, located in a large, active, continental rift in central Asia, image three major stratigraphic units totalling 3.5 to 7.5 km thick in four subbasins. A major change in rift deposition and faulting between the oldest and middle-rift units probably corresponds to the change from slow to fast rifting. A brief comparison of the basins of Lake Baikal with those of the East African rift system highlights differences in structural style that can be explained by differences in age and evolution of the surrounding basement rocks. -from Authors

Lake Baikal↗
USGS1992

A method of estimating the amount of in-situ gas hydrates in deep marine sediments

The bulk volume of gas hydrate in marine sediment can be estimated by measuring interval velocities and amplitude blanking of hydrated zones from true-amplitude processed multichannel seismic reflection data. In general, neither velocity nor amplitude information is adequate to independently estimate hydrate concentration. We propose a method that uses amplitude blanking calibrated by interval-velocity information to quantify hydrate concentrations in the Blake Ridge area of the U.S. Atlantic continental margin. On the Blake Ridge, blanking occurs in conjunction with relatively low interval velocities. The model that best explains this relation linearly mixes two end-member sediments, hydrated and unhydrated sediment. Hydrate concentration in the hydrate end-member can be calculated from a weighted equation that uses velocity estimated from the seismic data, known properties of pure hydrate, and porosity inferred from a velocity/porosity relationship. Amplitude blanking can be predicted as the proportions of hydrated and unhydrated sediment change across a reflection boundary. Our analysis of a small area near DSDP 533 indicates that the amount of gas hydrates is about 6% in total volume when interval velocity is used as a criterion and about 9.5% when amplitude information is used. This compares with a calculated value of about 8% derived from the only available measurement in DSDP 533.

Open-File Report↗
USGS1989

Processing and attenuation of noise in deep seismic-reflection data from the Gulf of Maine

The U.S. Geological Survey deep crustal studies reflection profile across the Gulf of Maine off southeastern New England was affected by three sources of noise: side-scattered noise, multiples, and 20-Hz whale sounds. The special processing most effective in minimizing this noise consisted of a combination of frequency-wavenumber (F-K) filtering, predictive deconvolution, and spectral whitening, each applied in the shot domain (prestack). Application of the F-K filter to remove side-scatter noise in the poststack domain resulted in a much poorer quality profile. The prestack noise suppression processing techniques resulted in a reflection profile with good signal-to-noise ratios and reliable strong reflections, especially at depths equivalent to the lower crust (24-34 km). Certain geologic features, such as a buried rift basin and a crustal fault are resolved much better within the upper crust after this processing. Finite difference migration of these data using realistic velocities produced excellent results. Migration was essential to distinguish between abundant dipping and subhorizontal reflections in the lower crust as well as to show an essentially transparent upper mantle. ?? 1989 Kluwer Academic Publishers.

Marine Geophysical Research↗
USGS1986

Free-air gravity anomaly map of the Long Island Platform

The U.S. Geological Survey (USGS) has collected marine gravity data along the U.S. Atlantic continental margin during the last decade. This map of the Long Island platform combines the data used to make the preliminary free-air gravity anomaly map of the Atlantic continental margin (Grow and others, 1976) with the new gravity values collected aboard the RV Gilliss in 1979 and the RV Gyre in 1981. Carl Bowin provided the USNS Kealthley data from the Woods Hole Oceanographic Institution gravity data-base. We thank Bab Bowles (USGS) for his advice on editing the navigation and gravity data.

Long Island↗
USGS1984

Water gun vs air gun: A comparison

The water gun is a relatively new marine seismic sound source that produces an acoustic signal by an implosive rather than explosive mechanism. A comparison of the source characteristics of two different-sized water guns with those of conventional air guns shows the the water gun signature is cleaner and much shorter than that of a comparable-sized air gun: about 60-100 milliseconds (ms) for an 80-in3. (1.31-liter (I)) water gun compared with several hundred ms for an 80-in3. (1.31-1) air gun. The source spectra of water guns are richer in high frequencies (>200 Hz) than are those of air guns, but they also have less energy than those of air guns at low frequencies. A comparison between water gun and air gun reflection profiles in both shallow (Long Island Sound)-and deep (western Bermuda Rise)-water settings suggests that the water gun offers a good compromise between very high resolution, limited penetration systems (e.g. 3.5-kHz profilers and sparkers) and the large volume air guns and tuned air gun arrays generally used where significant penetration is required. ?? 1984 D. Reidel Publishing Company.

Marine Geophysical Research↗
USGS1982

Deep structure and evolution of the Carolina Trough

Multichannel seismic-reflection data together with two-dimensional gravity and magnetic models suggest that the crustal structure off North Carolina consists of normal continental crust landward of the Brunswick magnetic anomaly (BMA), rift-stage crust in the 80-km-wide zone between the BMA and the East Coast magnetic anomaly (ECMA), and normal oceanic crust seaward of the ECMA.

Book chapter↗