Geology topics

C.C. Casey

Publications and source records attributed to C.C. Casey.

5 recordsLinked to original sources

USGS2007

Influence of dissolved oxygen convection on well sampling

Convective transport of dissolved oxygen (D.O.) from shallow to deeper parts of wells was observed as the shallow water in wells in South Carolina became cooler than the deeper water in the wells due to seasonal changes. Wells having a relatively small depth to water were more susceptible to thermally induced convection than wells where the depth to water was greater because the shallower water levels were more influenced by air temperature. The potential for convective transport of D.O. to maintain oxygenated conditions in a well screened in an anaerobic aquifer was diminished as ground water exchange through the well screen increased and as oxygen demand increased. Transport of D.O. to the screened interval can adversely affect the ability of passive samplers to produce accurate concentrations of oxygen-sensitive solutes such as iron, other redox indicators, and microbiological data. A comparison of passive sampling to low-flow sampling in a well undergoing convection, however, showed general agreement of volatile organic compound concentrations. During low-flow sampling, the pumped water may be a mixture of convecting water from within the well casing and aquifer water moving inward through the screen. This mixing of water during low-flow sampling can substantially increase equilibration times, can cause false stabilization of indicator parameters, can give false indications of the redox state, and can provide microbiological data that are not representative of the aquifer conditions. Data from this investigation show that simple in-well devices can effectively mitigate convective transport of oxygen. The devices can range from inflatable packers to simple, inexpensive baffle systems. ?? 2007 National Ground Water Association.

Ground Water Monitoring and Remediation↗

USGS2005

Geophysical monitoring of a field-scale biostimulation pilot project

The USGS conducted a geophysical investigation in support of a U.S. Naval Facilities Engineering Command, Southern Division field‐scale biostimulation pilot project at Anoka County Riverfront Park (ACP), downgradient of the Naval Industrial Reserve Ordnance Plant, Fridley, Minnesota. The goal of the pilot project is to evaluate subsurface injection of vegetable oil emulsion (VOE) to stimulate microbial degradation of chlorinated hydrocarbons. To monitor the emplacement and movement of the VOE and changes in water chemistry resulting from VOE dissolution and/or enhanced biological activity, the USGS acquired cross‐hole radar zero‐offset profiles, traveltime tomograms, and borehole geophysical logs during five site visits over 1.5 years. Analysis of pre‐ and postinjection data sets using petrophysical models developed to estimate VOE saturation and changes in total dissolved solids provides insights into the spatial and temporal distribution of VOE and ground water with altered chemistry. Radar slowness‐difference tomograms and zero‐offset slowness profiles indicate that the VOE remained close to the injection wells, whereas radar attenuation profiles and electromagnetic induction logs indicate that bulk electrical conductivity increased downgradient of the injection zone, diagnostic of changing water chemistry. Geophysical logs indicate that some screened intervals were located above or below zones of elevated dissolved solids; hence, the geophysical data provide a broader context for interpretation of water samples and evaluation of the biostimulation effort. Our results include (1) demonstration of field and data analysis methods for geophysical monitoring of VOE biostimulation and (2) site‐specific insights into the spatial and temporal distributions of VOE at the ACP.

Minnesota↗

USGS2005

Behavior of a chlorinated ethene plume following source-area treatment with Fenton's reagent

Monitoring data collected over a 6‐year period show that a plume of chlorinated ethene–contaminated ground water has contracted significantly following treatment of the contaminant source area using in situ oxidation. Prior to treatment (1998), concentrations of perchloroethene (PCE) exceeded 4500 μg/L in a contaminant source area associated with a municipal landfill in Kings Bay, Georgia. The plume emanating from this source area was characterized by vinyl chloride (VC) concentrations exceeding 800 μg/L. In situ oxidation using Fenton's reagent lowered PCE concentrations in the source area below 100 μg/L, and PCE concentrations have not rebounded above this level since treatment. In the 6 years following treatment, VC concentrations in the plume have decreased significantly. These concentration declines can be attributed to the movement of Fenton's reagent–treated water downgradient through the system, the cessation of a previously installed pump‐and‐treat system, and the significant natural attenuation capacity of this anoxic aquifer. While in situ oxidation briefly decreased the abundance and activity of microorganisms in the source area, this activity rebounded in <6 months. Nevertheless, the shift from sulfate‐reducing to Fe(III)‐reducing conditions induced by Fenton's treatment may have decreased the efficiency of reductive dechlorination in the injection zone. The results of this study indicate that source‐area removal actions, particularly when applied to ground water systems that have significant natural attenuation capacity, can be effective in decreasing the areal extent and contaminant concentrations of chlorinated ethene plumes.

Ground Water Monitoring and Remediation↗

USGS2004

Application of cross-borehole radar to monitor fieldscale vegetable old injection experiments for biostimulation

Cross-borehole radar methods were used to monitor a field-scale biostimulation pilot project at the Anoka County Riverfront Park (ACP), located downgradient of the Naval Industrial Reserve Ordnance Plant, in Fridley, Minnesota. The goal of the pilot project is to evaluate biostimulation using emulsified vegetable oil to treat ground water contaminated with chlorinated hydrocarbons. Vegetable oil is intended to serve as substrate to naturally occurring microbes, which ultimately break down chlorinated hydrocarbons into chloride, carbon dioxide, and water through oxidation-reduction reactions. In support of this effort, cross-borehole radar data were acquired by the U.S Geological Survey in five site visits over 1.5 years. This paper presents level-run (zero-offset profile) and time-lapse radar tomography data collected in multiple planes. Comparison of pre- and post-injection data sets provides valuable insights into the spatial and temporal distribution of both emulsified vegetable oil and also the extent of ground water with altered chemistry resulting from injections — information important for understanding microbial degradation of chlorinated hydrocarbons at the site. In order to facilitate data interpretation and test the effectiveness of radar for monitoring oil-emulsion placement and movement, three injection mixtures with different radar signatures were used: (1) vegetable oil emulsion, (2) vegetable oil emulsion with a colloidal iron tracer, and (3) vegetable oil emulsion with a magnetite tracer. Based on petrophysical modeling, mixture (1) is expected to increase radar velocity and decrease radar attenuation relative to background — a water-saturated porous medium; mixtures (2) and (3) are expected to increase radar velocity and also increase radar attenuation due to their greater electrical conductivity compared to native ground water. Radar slowness (inverse radar velocity) tomograms and level-run profiles show decreases in slowness in the vicinity of injection wells. Slowness anomalies are observed only in planes connected to injection wells, indicating that the emplaced emulsified vegetable oil does not migrate far after injection. In contrast to the localization of slowness anomalies, attenuation anomalies are observed in all level-run profiles, particularly those downgradient of the injection wells. Despite the expected signatures of different tracers, increases in attenuation are observed downgradient of all three injections; thus, we infer that the attenuation changes do not result from the iron tracers. One viable explanation for the observed attenuation changes is that products of oil-enhanced biodegradation (for example, ferrous iron) increase electrical conductivity of ground water and thus radar attenuation. Application of radar methods to data from the ACP demonstrated the utility of radar for monitoring biostimulation. Results of level-run and tomographic surveys identified (1) the distribution of emulsified vegetable oil, and (2) the distribution of ground water with oil-affected chemistry. Ongoing research efforts include simultaneous tomographic inversion of radar data from multiple planes, petrophysical modeling, geostatistical interpolation, and development of an integrated interpretation considering conventional borehole logs and surface-to-borehole radar data.

Minnesota↗

USGS2003

Object-based inversion of crosswell radar tomography data to monitor vegetable-oil injection experiment

Crosswell radar tomography methods can be used to dynamically image ground-water flow and mass transport associated with tracer tests, hydraulic tests, and natural physical processes. Dynamic imaging can be used to identify preferential flow paths and to help characterize complex aquifer heterogeneity. Unfortunately, because the raypath coverage of the interwell region is limited by the borehole geometry, the tomographic inverse problem is typically underdetermined, and tomograms may contain artifacts such as spurious blurring or streaking that confuse interpretation. We implement object-based inversion (using a constrained, non-linear, least-squares algorithm) as an alternative to pixel-based inversion approaches that utilize regularization (such as damping or smoothing criteria). Our approach requires pre- and post-injection travel-time data. Parameterization of the image plane comprises a small number of objects rather than a large number of pixels, resulting in an overdetermined problem that reduces the need for prior information. The nature and geometry of the objects are based on hydrologic insight into aquifer characteristics, the nature of the experiment, and the planned use of the geophysical results. The object-based inversion approach is demonstrated using synthetic and crosswell radar field data acquired during vegetable-oil injection experiments at a site in Fridley, Minnesota. The region where oil has displaced ground water is discretized as a stack of rectangles of variable horizontal extents. The inversion provides the geometry of the affected region and an estimate of the radar slowness change for each rectangle. Applying petrophysical models to these results and porosity from neutron logs, we estimate that the vegetable-oil emulsion saturation in various layers ranges from 60 to 90%. Further work is needed to assess the accuracy of the emulsion saturation estimates. Using synthetic- and field-data examples, the object-based inversion approach is shown to be an effective strategy for inverting crosswell radar tomography data acquired to monitor the emplacement of vegetable-oil emulsions. A principal advantage of object-based inversion is that it yields images that hydrologists and engineers can easily interpret and use for model calibration.

Conference Paper↗