Geology ReportsSearch

Geology topics

C. K. Harris

Publications and source records attributed to C. K. Harris.

4 recordsLinked to original sources

Deposition and flux of sediment from the Po River, Italy: An idealized and wintertime numerical modeling study

Recent studies of sediment dynamics and clinoform development in the northern Adriatic Sea focused on winter 2002-2003 and provided the data and motivation for development of a detailed sediment-transport model for the area near the Po River delta. We used both idealized test cases and more realistic simulations to improve our understanding of seasonal sediment dynamics there. We also investigated the relationship between physical processes and the observed depositional products; e.g. the accumulation of sediment very near the Po River distributary mouths. Sediment transport near the Po River was evaluated using a three-dimensional ocean model coupled to sediment-transport calculations that included wave- and current-induced resuspension, suspended-sediment transport, multiple grain classes, and fluvial input from the Po River. High-resolution estimates from available meteorological and wave models were used to specify wind, wave, and meteorological forcing. Model results indicated that more than half of the discharged sediment remained within 15??km of the Po River distributary mouths, even after two months of intensive reworking by winter storms. During floods of the Po River, transport in the middle to upper water column dominated sediment fluxes. Otherwise, sediment fluxes from the subaqueous portion of the delta were confined to the bottom few meters of the water column, and correlated with increases in current speed and wave energy. Spatial and temporal variation in wind velocities determined depositional patterns and the directions of sediment transport. Northeasterly Bora winds produced relatively more eastward transport, while southwesterly Sirocco winds generated fluxes towards both the north and the south. Eastward transport accounted for the majority of the sediment exported from the subaqueous delta, most likely due to the frequent occurrence of Bora conditions. Progradation of the Po River delta into the Adriatic Sea may restrict the formation of the Western Adriatic Coastal Current, increasing sediment retention at the Po delta and reducing the supply of sediment to the Apennine margin. A positive morphodynamic feedback may therefore be present whereby the extension of the delta into the Adriatic increases sediment accumulation at the delta and facilitates further progradation. ?? 2009 Elsevier B.V.

Marine Geology

Development of a three-dimensional, regional, coupled wave, current, and sediment-transport model

We are developing a three-dimensional numerical model that implements algorithms for sediment transport and evolution of bottom morphology in the coastal-circulation model Regional Ocean Modeling System (ROMS v3.0), and provides a two-way link between ROMS and the wave model Simulating Waves in the Nearshore (SWAN) via the Model-Coupling Toolkit. The coupled model is applicable for fluvial, estuarine, shelf, and nearshore (surfzone) environments. Three-dimensional radiation-stress terms have been included in the momentum equations, along with effects of a surface wave roller model. The sediment-transport algorithms are implemented for an unlimited number of user-defined non-cohesive sediment classes. Each class has attributes of grain diameter, density, settling velocity, critical stress threshold for erosion, and erodibility constant. Suspended-sediment transport in the water column is computed with the same advection-diffusion algorithm used for all passive tracers and an additional algorithm for vertical settling that is not limited by the CFL criterion. Erosion and deposition are based on flux formulations. A multi-level bed framework tracks the distribution of every size class in each layer and stores bulk properties including layer thickness, porosity, and mass, allowing computation of bed morphology and stratigraphy. Also tracked are bed-surface properties including active-layer thickness, ripple geometry, and bed roughness. Bedload transport is calculated for mobile sediment classes in the top layer. Bottom-boundary layer submodels parameterize wave-current interactions that enhance bottom stresses and thereby facilitate sediment transport and increase bottom drag, creating a feedback to the circulation. The model is demonstrated in a series of simple test cases and a realistic application in Massachusetts Bay.

Computers & Geosciences

Winter-time circulation and sediment transport in the Hudson Shelf Valley

The Hudson Shelf Valley is a bathymetric low that extends across the continental shelf offshore of New York and New Jersey. From December 1999 to April 2000 a field experiment was carried out to investigate the transport of sediment in the shelf and valley system. Near-bed tripods and water-column moorings were deployed at water depths from 38 to 75 m in the axis of the shelf valley and at about 26 m on the adjacent shelves offshore of New Jersey and Long Island, New York. These measured suspended sediment concentrations, current velocities, waves, and water column properties. This paper analyzes observations made during December 1999 and January 2000, and presents the first direct near-bed measurements of suspended sediment concentration and sediment flux from the region. Sediment transport within the Hudson Shelf Valley was coherent over tens of kilometers, and usually aligned with the axis of the shelf valley. Down-valley (off-shore) transport was associated with energetic waves, winds from the east, moderate current velocities (5-10 cm/s), and sea level setup at Sandy Hook, NJ. Up-valley (shoreward) transport occurred frequently, and was associated with winds from the west, low wave energy, high current velocities (20-40 cm/s), and sea level set-down at the coast. Within the shelf valley, net sediment flux (the product of near-bed concentration and velocity) was directed shoreward, up the axis of the valley. Current velocities and suspended sediment fluxes on the New York and New Jersey continental shelves were lower than within the shelf valley, and exhibited greater variability in alignment. Longer term meteorological data indicate that wind, setup, and wave conditions during the study period were more conducive to up-valley transport than seasonal data suggest as average. To relate the observed up-valley sediment flux to observed accumulation of contaminants within the Hudson Shelf Valley requires consideration of transport over longer timescales than those observed here, and methods that account for the region's complex bathymetry, sediment distribution, and circulation. ?? 2003 Elsevier Science Ltd. All rights reserved.

New Jersey, New York

A two-dimensional, time-dependent model of suspended sediment transport and bed reworking for continental shelves

A two-dimensional, time-dependent solution to the transport equation is formulated to account for advection and diffusion of sediment suspended in the bottom boundary layer of continental shelves. This model utilizes a semi-implicit, upwind-differencing scheme to solve the advection-diffusion equation across a two-dimensional transect that is configured so that one dimension is the vertical, and the other is a horizontal dimension usually aligned perpendicular to shelf bathymetry. The model calculates suspended sediment concentration and flux; and requires as input wave properties, current velocities, sediment size distributions, and hydrodynamic sediment properties. From the calculated two-dimensional suspended sediment fluxes, we quantify the redistribution of shelf sediment, bed erosion, and deposition for several sediment sizes during resuspension events. The two-dimensional, time-dependent approach directly accounts for cross-shelf gradients in bed shear stress and sediment properties, as well as transport that occurs before steady-state suspended sediment concentrations have been attained. By including the vertical dimension in the calculations, we avoid depth-averaging suspended sediment concentrations and fluxes, and directly account for differences in transport rates and directions for fine and coarse sediment in the bottom boundary layer. A flux condition is used as the bottom boundary condition for the transport equation in order to capture time-dependence of the suspended sediment field. Model calculations demonstrate the significance of both time-dependent and spatial terms on transport and depositional patterns on continental shelves. ?? 2001 Elsevier Science Ltd. All rights reserved.

Computers & Geosciences