Geology topics

Benjamin J. Dietsch

Publications and source records attributed to Benjamin J. Dietsch.

23 records · Page 2Linked to original sources

USGS2009

Hydrodynamic simulations of physical aquatic habitat availability for Pallid Sturgeon in the Lower Missouri River, at Yankton, South Dakota, Kenslers Bend, Nebraska, Little Sioux, Iowa, and Miami, Missouri, 2006-07

The objective of this study was to assess the sensitivity of habitat availability in the Lower Missouri River to discharge variation, with emphasis on habitats that might support spawning of the endangered pallid sturgeon. We constructed computational hydrodynamic models for four reaches that were selected because of evidence that sturgeon have spawned in them. The reaches are located at Miami, Missouri (river mile 259.6–263.5), Little Sioux, Iowa (river mile 669.6–673.5), Kenslers Bend, Nebraska (river mile 743.9–748.1), and Yankton, South Dakota reach (river mile 804.8–808.4). The models were calibrated for a range of measured flow conditions, and run for a range of discharges that might be affected by flow modifications from Gavins Point Dam. Model performance was assessed by comparing modeled and measured water velocities. A selection of derived habitat units was assessed for sensitivity to hydraulic input parameters (drag coefficient and lateral eddy viscosity). Overall, model results were minimally sensitive to varying eddy viscosity; varying lateral eddy viscosity by 20 percent resulted in maximum change in habitat units of 5.4 percent. Shallow-water habitat units were most sensitive to variation in drag coefficient with 42 percent change in unit area resulting from 20 percent change in the parameter value; however, no habitat unit value changed more than 10 percent for a 10 percent variation in drag coefficient. Sensitivity analysis provides guidance for selecting habitat metrics that maximize information content while minimizing model uncertainties. To assess model sensitivities arising from topographic variation from sediment transport on an annual time scale, we constructed separate models from two complete independent surveys in 2006 and 2007. The net topographic change was minimal at each site; the ratio of net topographic change to water volume in the reaches at 95 percent exceedance flow was less than 5 percent, indicating that on a reach-average basis, annual topographic change contributed little to habitat area variation. Net erosion occurred at Yankton (the upstream reach) and because erosion was distributed uniformly, there was little affect on many habitat metrics. Topographic change was spatially nonuniform at Little Sioux and Kenslers Bend reaches. Shallow water habitat units and some reach-scale patch statistics (edge density, patch density, and Simpson’s Diversity Index) were affected by these changes. Erosion dominated at the downstream reach but habitat metrics did not vary substantially from 2006 to 2007. Among habitat metrics that were explored, zones of convergent flow were identified as areas that most closely correspond to spawning habitats of other sturgeon species, as identified in the scientific literature, and that are consistent with sparse data on pallid sturgeon spawning locations in the Lower Missouri River. Areas of convergent zone habitat varied little with discharges that would be associated with spring pulsed flows, and relations with discharge changed negligibly between 2006 and 2007. Other habitat measures show how physical habitat varies with discharge and among the four reaches. Wake habitats defined by velocity gradients seem to correspond with migration pathways of adult pallid sturgeon. Habitats with low Froude-number correspond to low energy areas that may accumulate passively transporting particles, organic matter, and larval fish. Among the modeled reaches, Yankton had substantially longer water residence time for equivalent flow exceedances than the other three modeled reaches. Longer residence times result from greater flow resistance in the relatively wide, shallow channel and may be associated with longer residence times of passively transported particulate materials.

Scientific Investigations Report↗

USGS2008

Estimated Flood Discharges and Map of Flood-Inundated Areas for Omaha Creek, near Homer, Nebraska, 2005

Repeated flooding of Omaha Creek has caused damage in the Village of Homer. Long-term degradation and bridge scouring have changed substantially the channel characteristics of Omaha Creek. Flood-plain managers, planners, homeowners, and others rely on maps to identify areas at risk of being inundated. To identify areas at risk for inundation by a flood having a 1-percent annual probability, maps were created using topographic data and water-surface elevations resulting from hydrologic and hydraulic analyses. The hydrologic analysis for the Omaha Creek study area was performed using historical peak flows obtained from the U.S. Geological Survey streamflow gage (station number 06601000). Flood frequency and magnitude were estimated using the PEAKFQ Log-Pearson Type III analysis software. The U.S. Army Corps of Engineers' Hydrologic Engineering Center River Analysis System, version 3.1.3, software was used to simulate the water-surface elevation for flood events. The calibrated model was used to compute streamflow-gage stages and inundation elevations for the discharges corresponding to floods of selected probabilities. Results of the hydrologic and hydraulic analyses indicated that flood inundation elevations are substantially lower than from a previous study.

Scientific Investigations Report↗

USGS2007

An Assessment of Hydrology, Fluvial Geomorphology, and Stream Ecology in the Cardwell Branch Watershed, Nebraska, 2003-04

An assessment of the 16.3-square-mile Cardwell Branch watershed characterized the hydrology, fluvial geomorphology, and stream ecology in 2003-04. The study - performed by the U.S. Geological Survey in cooperation with the City of Lincoln, Nebraska, and the Lower Platte South Natural Resources District - focused on the 7.7-square-mile drainage downstream from Yankee Hill Reservoir. Hydrologic and hydraulic models were developed using the Hydrologic Modeling System (HEC-HMS) and River Analysis System (HEC-RAS) of the U.S. Army Corps of Engineers Hydraulic Engineering Center. Estimates of streamflow and water-surface elevation were simulated for 24-hour-duration design rainstorms ranging from a 50-percent frequency to a 0.2-percent frequency. An initial HEC-HMS model was developed using the standardized parameter estimation techniques associated with the Soil Conservation Service curve number technique. An adjusted HEC-HMS model also was developed in which parameters were adjusted in order for the model output to better correspond to peak streamflows estimated from regional regression equations. Comparisons of peak streamflow from the two HEC-HMS models indicate that the initial HEC-HMS model may better agree with the regional regression equations for higher frequency storms, and the adjusted HEC-HMS model may perform more closely to regional regression equations for larger, rarer events. However, a lack of observed streamflow data, coupled with conflicting results from regional regression equations and local high-water marks, introduced considerable uncertainty into the model simulations. Using the HEC-RAS model to estimate water-surface elevations associated with the peak streamflow, the adjusted HEC-HMS model produced average increases in water-surface elevation of 0.2, 1.1, and 1.4 feet for the 50-, 1-, and 0.2-percent-frequency rainstorms, respectively, when compared to the initial HEC-HMS model. Cross-sectional surveys and field assessments conducted between November 2003 and March 2004 indicated that Cardwell Branch and its unnamed tributary appear to be undergoing incision (the process of downcutting) (with three locations showing 2 or more feet of streambed incision since 1978) that is somewhat moderated by the presence of grade controls and vegetation along the channel profile. Although streambank failures were commonly observed, 96 percent of the surveyed cross sections were classified as stable by planar and rotational failure analysis-a disconnect that may have been the result of assumed soil properties. Two process-based classification systems each indicated that the reaches within the study area were incising and widening, and the Rosgen classification system characterized the streams as either type E6 or B6c. E6 channels are hydraulically efficient with low width-depth ratios, low to moderate sinuosity, and gentle to moderately steep slopes. B6c channels typically are incised with low width-depth ratios maintained by riparian vegetation, low bedload transport, and high washload transport. No obvious nickpoints (interruption or break in slope) were observed in the thalweg profile (line of maximum streambed descent), and the most acute incision occurred immediately downstream from bridges and culverts. Nine water-quality samples were collected between August 2003 and November 2004 near the mouth of the watershed. Sediment-laden rainfall-runoff substantially affected the water quality in Cardwell Branch, leading to greater biochemical and chemical oxygen demands as well as increased concentrations of several nutrient, bacteriological, sediment, and pesticide constituents. The storage of rainfall runoff in Yankee Hill Reservoir may prolong the presence of runoff-related constituents downstream. Across the study area, there was a lack of habitat availability for aquatic biota because of low dissolved oxygen levels and low streamflows or dry channels. In August 2003, the aquatic community near the mouth of

Scientific Investigations Report↗

USGS2003

Streambed adjustment and channel widening in eastern Nebraska

In eastern Nebraska, stream straightening and dredging efforts since the 1890s have disturbed the natural equilibrium of stream channels and have led to streambed adjustment by degradation and subsequent channel widening. This report describes a study to evaluate the effect these disturbances have had on stream channels in eastern Nebraska. Two sets of survey data were collected approximately 2 years apart during 1996-99 at 151 primary sites. Additionally, historical streambed-elevation data (dating back to the 1890s) were compiled from several sources for the primary sites and 45 supplemental sites, and relevant disturbances were identified for each of eight basin groupings. Streambed-elevation data sets were used to estimate the amount of change to the streambed at the sites over the time period of the data. Recent channel widening was documented for 73 of the primary sites by comparing the two survey sets. The majority of observed streambed-gradation responses appear to be related to the various straightening efforts and to the effects of grade-control structures in the study area. Channel responses were complicated by the presence of multiple disturbances. However, in many cases, the streambed-elevation data sets provide a reliable representation of the past streambed gradation, with some sites showing 6 to 7 meters of degradation since they were straightened. Many sites that had been straightened showed considerable degradation following the disturbance. This indicates that eastern Nebraska stream channels can regain equilibrium mainly through the slope adjustment process of head-ward-progressing degradation. Bank failures were documented at sites in all eight of the basin groupings analyzed, and widening rates were computed at 64 of 73 sites. Observed bank widening in the Big Blue River Basin, a relatively unstraightened basin, indicates that other disturbances besides stream-channel straightening may be causing channel responses in the basin and possibly in the entire study area.

Water-Resources Investigations Report↗

USGS2003

Stream Bank Stability in Eastern Nebraska

Dredged and straightened channels in eastern Nebraska have experienced degradation leading to channel widening by bank failure. Degradation has progressed headward and affected the drainage systems upstream from the modified reaches. This report describes a study that was undertaken to analyze bank stability at selected sites in eastern Nebraska and develop a simplified method for estimating the stability of banks at future study sites. Bank cross sections along straight reaches of channel and geotechnical data were collected at approximately 150 sites in 26 counties of eastern Nebraska. The sites were categorized into three groups based on mapped soil permeability. With increasing permeability of the soil groups, the median cohesion values decreased and the median friction angles increased. Three analytical methods were used to determine if banks were stable (should not fail even when saturated), at risk (should not fail unless saturated), or unstable (should have already failed). The Culmann and Agricultural Research Service methods were based on the Coulomb equation and planar failure; an indirect method was developed that was based on Bishop's simplified method of slices and rotational failure. The maximum angle from horizontal at which the bank would be stable for the given soil and bank height conditions also was computed with the indirect method. Because of few soil shear-strength data, all analyses were based on the assumption of homogeneous banks, which was later shown to be atypical, at least for some banks. Using the Culmann method and assuming no soil tension cracks, 67 percent of all 908 bank sections were identified as stable, 32 percent were at risk, and 1 percent were unstable; when tension cracks were assumed, the results changed to 58 percent stable, 40 percent at risk, and 1 percent unstable. Using the Agricultural Research Service method, 67 percent of all bank sections were identified as stable and 33 percent were at risk. Using the indirect method, 62 percent of all bank sections were identified as stable and 31 percent were at risk; 3 percent were unstable, and 3 percent were outside of the range of the tables developed for the method. For each of the methods that were used, the largest percentage of stable banks and the smallest percentage of at risk banks was for the soil group with the lowest soil permeability and highest median cohesion values. A comparison of the expected stable bank angles for saturated conditions and the surveyed bank angles indicated that many of the surveyed bank angles were considerably less than the maximum expected stable bank angles despite the banks being classified as at risk or unstable. For severely degraded channels along straight reaches this was not expected. It was expected that they would have angles close to the maximum stable angle as they should have been failing from an oversteepened condition. Several explanations are possible. The channel reaches of some study sites have not yet been affected to a significant degree by degradation; study sites were selected throughout individual basins and severe degradation has not yet extended to some sites along upper reaches; and some reaches have experienced aggradation as degradation progresses upstream. Another possibility is that some bank sections have been affected by lateral migration processes, which typically result in shallow bank angles on the inside bend of the channel. Another possibility is that the maximum expected stable bank angles are too steep. The stability methods used were well established and in essential agreement with each other, and there was no reason to question the geometry data. This left non-representative soil data as a probable reason for computed stable bank angles that, at least in some cases, are overly steep. Based on an examination of the cohesion data, to which the stable bank-angle calculations were most sensitive, both vertical and horizontal variability in soil properti

Water-Resources Investigations Report↗