B. J. Skinner | Geology Reports

USGS2003

Geochemistry of the furnace magnetite bed, Franklin, New Jersey, and the relationship between stratiform iron oxide ores and stratiform zinc oxide-silicate ores in the New Jersey highlands

The New Jersey Highlands terrace, which is an exposure of the Middle Proterozoic Grenville orogenic belt located in northeastern United States, contains stratiform zinc oxide-silicate deposits at Franklin and Sterling Hill and numerous massive magnetite deposits. The origins of the zinc and magnetite deposits have rarely been considered together, but a genetic link is suggested by the occurrence of the Furnace magnetite bed and small magnetite lenses immediately beneath the Franklin zinc deposit. The Furnace bed was metamorphosed and deformed along with its enclosing rocks during the Grenvillian orogeny, obscuring the original mineralogy and obliterating the original rock fabrics. The present mineralogy is manganiferous magnetite plus calcite. Trace hydrous silicates, some coexisting with fluorite, have fluorine contents that are among the highest ever observed in natural assemblages. Furnace bed calcite has ??13C values of -5 ?? 1 per mil relative to Peedee belemnite (PDB) and ??18O values of 11 to 20 per mil relative to Vienna-standard mean ocean water (VSMOW). The isotopic compositions do not vary as expected for an original siderite layer that decarbonated during metamorphism, but they are consistent with nearly isochemical metamorphism of an iron oxide + calcite protolith that is chemically and minerlogically similar to iron-rich sediments found near the Red Sea brine pools and isotopically similar to Superior-type banded iron formations. Other magniferous magnite + calcite bodies occur at approximately the same stratigraphic position as far 50 km from the zinc deposits. A model is presented in which the iron and zinc deposits formed along the western edge of a Middle Proterozoic marine basin. Zinc was transported by sulfate-stable brines and was precipitated under sulfate-stable conditions as zincian carbonates and Fe-Mn-Zn oxides and silicates. Whether the zincian assemblages settled from the water column or formed by replacement reactions in shallowly buried sediments is uncertain. The iron deposits formed at interfaces between anoxic and oxygenated waters. The Furnace magnetite bed resulted from seawater oxidation of hydrothermally transported iron near a brine conduit. Iron deposits also formed regionally on the basin floor at the interface betveen anoxic deep waters and oxygenated shallower waters. These deposits include not only manganiferous magnetite + calcite bodies similar to the Furnace magnetite bed but also silicate-facies deposits that formed by iron oxide accumulation where detrital sediment was abundant. A basin margin model can be extended to Grenvillian stratiform deposits in the northwest Adirondacks of New York and the Mont Laurier basin of Quebec. In these areas iron deposits (pyrite or magnetite) are found basinward of marble-hosted sphalerite deposits, such as those in the Balmat-Edwards district. Whether the iron and zinc precipitated as sulfide assemblages or carbonate-oxide-silicate assemblages depended on whether sufficient organic matter or other reductants were available in local sediments or bottom waters to stabilize H2S.

New Jersey↗

USGS1968

Experimental evidence that fluid inclusions do not leak

The possibility of leakage of fluids into or out of fluid inclusions subjected to large pressure gradients has always been considered a serious problem in the interpretation of inclusion data. As previous experimental evidence on leakage was contradictory, new experiments were performed. Inclusion vapor bubble diameters in twelve quartz crystals (≤ 3 mm; 8 localities), not sawn, ground or polished, were measured. The samples were run at Pa-.o,-4,000 bars, at T u 100°-410° C, for ≤ 17 days total, and remeasured after each run. Similar experiments at ≤ 155° C were made on sphalerite and calcite. Most inclusions in most samples (even those only 5am under the surface in quartz) showed no change in bubble diameter, hence no leakage. A few exceptions, mainly among inclusions homogenizing at T « Tru, had P internal » P internal , hence they ruptured and lost liquid during the 410° C run. From this work and a review of the literature, we conclude that most inclusions have not suffered major leakage. Some previous experiments indicating leakage may be explained by microfractures introduced during sample preparation. The present work does not , however, preclude the possibility of diffusion of small but chemically significant amounts of substances such as hydrogen in or out of inclusions .

Economic Geology↗

USGS1965

The system arsenic-antimony

The one atmosphere isobaric phase relations have been determined for the system As-Sb, using a simple experimental arrangement where a low melting temperature alkali halide melt acts as a reaction vessel. The one atmosphere univariant temperature, where a liquid of composition 45.5 mol % As, plus a solid of composition 62 mol % As and a gas of composition 89 mol % As coexist, is 666° ± 3° C. The one atmosphere sublimation point of As was measured as 611° ±2° C. Arsenic and antimony are hexagonal isostructural compounds with a complete solid solution series between them. The a cell edge and volume of the unit cell vary linearly with composition in mol percent. The c edge changes in a markedly nonlinear manner with composition. The measured unit-cell parameters at 25° C are: As, a = 3.760 ± 0.001 A, c = 10.555 ± 0.003A, V = 129.2A3; Sb, a = 4.310 ± 0.001 A, c - 11.279 ± 0.003A, V = 181.4A3.

Economic Geology↗