Geology Reports⌕ Search

Geology topics

Ann Zurawski

Publications and source records attributed to Ann Zurawski.

5 recordsLinked to original sources

Ground water in carbonate rocks and regolith in the Fairview area, Tennessee

Fourteen test wells drilled in the Fairview area, Tennessee, produce from 3 to 100 gallons per minute and have an average yield of 32 gallons per minute, measured while blowing water from the wells with compressed air. In comparison, the average yield of supply wells reported by drillers is 13 gallons per minute. Specific capacities for three of the test wells ranged from 0.3 to 0.6 gallons per minute per foot of drawdown after 8 hours of pumping at 20 to 47 gallons per minute. Two test wells had specific capacities of 1.1 and 0.4 gallons per foot of drawdown after 72 hours of pumping at 55 and 43 gallons per minute. The mineral content of ground water increases greatly below a gypsum horizon approximately 100 feet below the top of the Fort Payne Formation. Ground water above the gypsum horizon, however, meets the standards for finished drinking water. (USGS)

Water-Resources Investigations Report↗

Ground water in the carbonate rocks of the Franklin area, Tennessee

A study of ground water in the Franklin area, Tennessee, was undertaken to fill a growing need for information on ground-water occurrence in the carbonate rocks of central Tennessee. Fifteen drilling sites were selected that had one or more of the following characteristics: medium-to thick-bedded limestones within 200 feet of land surface, structural lows, significant streamflow gains and losses, elongated sinkholes, straight stream reaches, linear features or other surface indications of solution cavities at depth. The 15 test wells produced from less than 1 to about 600 gallons per minute and had an average yield of 68 gallons per minute, measured while pumping the wells with compressed air. The average driller-reported yield for the area is five gallons per minute. Specific capacities for the four highest yielding wells ranged from 0.6 to 357 gallons per minute per foot of drawdown after 8 hours of pumping at rates ranging from 70 to 225 gallons per minute. Additional drilling at two sites revealed extensive solution openings. At one site, drawdown in five observation wells did not exceed 8.5 feet during 48 hours of pumping at an average rate of 502 gallons per minute. Raw water in the test wells meets most drinking-water standards and is of rather uniform quality from well to well and throughout the year.

Tennessee↗

Hydrogeology of the Gatlinburg area, Tennessee

A study of ground-water availability in the Gatlinburg area, Tenn., was undertaken to improve concepts of ground-water occurrence in the Blue Ridge and demonstrate that ground water is present in sufficient quantities to provide an alternative to surface water as a source of supply. Of 25 test wells, 8 produced between 50 and 116 gallons per minute. The Gatlinburg area, located on the northern flank of the Great Smoky Mountains , is underlain by fractured, variably metamorphosed, sedimentary rocks. The most effective criteria for choosing well sites were valley areas with 7 percent or less land slope, presence of fracture traces, and deep overburden. Mapped faults were not a good indicator of ground-water occurrence. The largest amounts of ground water occur in irregularly shaped zones of deep and intense weathering in the rocks underlying broad, fracture-controlled valleys. Permeable zones along fractures at depths of 170 feet or less supply most of the water. (USGS)

Open-File Report↗

Summary appraisals of the nation's ground-water resources – Tennessee region

Ground water is an abundant and little-used resource in the Tennessee Region, a 41,000 square mile area dominated by the Tennessee River system and including parts of Alabama, Georgia, Kentucky, Mississippi, North Carolina, Tennessee, and Virginia. One-fifth to one-fourth of the precipitation that falls on the region enters the ground-water reservoirs. During the year approximately the same amount of water leaves the ground-water system, sustaining the dry-weather flow of streams. Recharge for the region is about 22,000 million gallons per day or 0.5 million gallons per day per square mile. The major types of aquifers in the region are unconsolidated material (including sand and regolith), carbonate rocks, and fractured noncarbonate rocks. One or more of these aquifer types occurs in each of the six physiographic subdivisions of the region. The productivity of these aquifers depends on their hydraulic properties and on the distribution of these properties. The unconsolidated sand aquifers are the most homogeneous in composition and most predictable in occurrence. These aquifers commonly yield 200 to 600 gallons per minute per well depending on the thickness of sand penetrated. The most difficult aquifers to predict in regard to depth and yield are the carbonate rocks. In these aquifers it is possible to drill dry holes within a few hundred feet of wells capable of producing several thousand gallons per minute. However, with an adequate reconnaissance study to determine the occurrence of ground water and a planned test drilling program, yields of up to 300 gallons per minute per well can be expected in the carbonate aquifers. Potential yields from the fractured noncarbonate aquifers are lower than in the carbonate rocks. The chemical and physical properties of ground water in the Tennessee Region are usually within the limits recommended by the Environmental Protection Agency for drinking water, and the ground water in all but some very shallow aquifers tends to be free of pathogenic microorganisms. Saline water is not known to occur in significant quantities in the region. In 1970, 173 million gallons per day of ground water were used in the Tennessee Region. This was less than 8 percent of the total quantity of water used in the region and only 0.8 percent of the estimated ground-water recharge. Ground water is used chiefly as a source of water supply for rural areas and small towns. A lesser amount is used by industries and commercial establishments located beyond the limits of municipal water-supply systems. However, there is potential for significantly increased use in order to augment surface-water supplies and to utilize the total water resource more efficiently. Hydrologic studies and adequate test drilling would greatly increase the chances of locating large amounts of ground water, especially in the nine-tenths of the Tennessee Region that is underlain by either carbonate rocks or fractured noncarbonate rocks which have highly variable water-bearing properties. Collectively, such studies are useful in developing a concept of the hydrologic system which would permit the development of criteria for selecting well sites in other areas with a similar geological and hydrological setting. Hydrologic studies that include test drilling have been conducted in all parts of the region except the Cumberland Plateau. Some of the basic data necessary for hydrologic studies, such as geologic maps, well records, and streamflow records are available throughout the region. However, detailed information on groundwater levels, ground-water quality, and aquifer characteristics are not equally available throughout the region. This type of information cannot be obtained quickly when it is needed; it must be the product of a continuing program of studies designed to evaluate the Tennessee Region's ground-water resource. Because of the interdependence of ground water and surface water, water management efforts can be fully effective only if they involve the whole water resource. In the Tennessee Region, surface water is highly controlled, but there is at present no regionwide water-resources management plan that includes ground water.

Tennessee↗