Geology ReportsSearch

Geology topics

A.J. Lembo

Publications and source records attributed to A.J. Lembo.

2 recordsLinked to original sources

Using occupancy models of forest breeding birds to prioritize conservation planning

As urban development continues to encroach on the natural and rural landscape, land-use planners struggle to identify high priority conservation areas for protection. Although knowing where urban-sensitive species may be occurring on the landscape would facilitate conservation planning, research efforts are often not sufficiently designed to make quality predictions at unknown locations. Recent advances in occupancy modeling allow for more precise estimates of occupancy by accounting for differences in detectability. We applied these techniques to produce robust estimates of habitat occupancy for a subset of forest breeding birds, a group that has been shown to be sensitive to urbanization, in a rapidly urbanizing yet biological diverse region of New York State. We found that detection probability ranged widely across species, from 0.05 to 0.8. Our models suggest that detection probability declined with increasing forest fragmentation. We also found that the probability of occupancy of forest breeding birds is negatively influenced by increasing perimeter-area ratio of forest fragments and urbanization in the surrounding habitat matrix. We capitalized on our random sampling design to produce spatially explicit models that predict high priority conservation areas across the entire region, where interior-species were most likely to occur. Finally, we use our predictive maps to demonstrate how a strict sampling design coupled with occupancy modeling can be a valuable tool for prioritizing biodiversity conservation in land-use planning. ?? 2009 Elsevier Ltd.

Biological Conservation

Use of airborne and terrestrial lidar to detect ground displacement hazards to water systems

We investigate the use of multiepoch airborne and terrestrial lidar to detect and measure ground displacements of sufficient magnitude to damage buried pipelines and other water system facilities that might result, for example, from earthquake or rainfall-induced landslides. Lidar scans are performed at three sites with coincident measurements by total station surveying. Relative horizontal accuracy is evaluated by measurements of lateral dimensions of well defined objects such as buildings and tanks; we find misfits ranging from approximately 5 to 12 cm, which is consistent with previous work. The bias and dispersion of lidar elevation measurements, relative to total station surveying, is assessed at two sites: (1) a power plant site (PP2) with vegetated steeply sloping terrain; and (2) a relatively flat and unvegetated site before and after trenching operations were performed. At PP2, airborne lidar showed minimal elevation bias and a standard deviation of approximately 70 cm, whereas terrestrial lidar did not produce useful results due to beam divergence issues and inadequate sampling of the study region. At the trench site, airborne lidar showed minimal elevation bias and reduced standard deviation relative to PP2 (6-20 cm), whereas terrestrial lidar was nearly unbiased with very low dispersion (4-6 cm). Pre- and posttrench bias-adjusted normalized residuals showed minimal to negligible correlation, but elevation change was affected by relative bias between epochs. The mean of elevation change bias essentially matches the difference in means of pre- and posttrench elevation bias, whereas elevation change standard deviation is sensitive to the dispersion of individual epoch elevations and their correlation coefficient. The observed lidar bias and standard deviations enable reliable detection of damaging ground displacements for some pipelines types (e.g., welded steel) but not all (e.g., concrete with unwelded, mortared joints). ?? ASCE 2009.

Journal of Surveying Engineering